ANYSECU N1201SA+ 34.375MHz - 2.7GHz UV RF Vector Impedance ANT SWR Antenna Analyzer Meter Tester resistance/impedance/SWR









Specifications:
working currency 34.375MHz~2700MHz
stepped frequency 1kHz
Display 2.4cun TFT trdp
resolution ratio 320*240(QVGA)
2000mAH(7.4Wh)
power consumption <1.5W
charge current 400mA
charge port USB
Auto power off can be set 5-60minutes
measured parameters resistence reactance standing wave s11
resolution ratio 4 number
frequency accuracy about 5ppm
Connector SMA-K
measurement range:
impedance:0.1~1000
standing wave:1.000~65

s11(dB):0dB~-60dB


Startup and shutdown

Hold down the CTRL key off press the power switch button.    
The boot state, long press (2S above) the switch button, after the release, the instrument will shut down    
The boot state, long press (2S above) the switch button, after the release, the instrument will shut down
Recommend the use

1. in order to ensure the accuracy of measurement and calibration, preheat the instrument at least 15 minutes.    

2.try to use good quality RF cable and connectors.    

3.calibrated cable marked to the next may not need to calibrate and direct use.    

4. test cable process affect the measurement accuracy, it is recommended that, where possible, do not choose too long test cable.    

5.measurement and calibration before, make sure you are not in a strong wireless signal, so as to avoid interference caused by inaccurate measurements.  

6.if the impedance measurements themselves do not understand, you can refer to a vector network analyzer instructions and tutorials. This instrument is equivalent to a single-port vector network analysis. 

Package Content:


1 x N1201SA+ Antenna Analyzer

1 x USB Cable

1 x adapter

1 x Manual