Phone or Tablet Holder for Wall, Pegboard, or Ryobi Link Wall Rails

This holds a wide variety of cell phones, tablets, and other devices at a 10-degree angle off the wall, pegboard, Ryobi Link Wall Rails.  The lip or groove is .67" (17mm) wide to accommodate thicker cases (see photos with diagrams for dimensions).  Thin devices work well, but angle slightly more than 10 degrees and lean against the back.  There is a slot between the 2 main supports to allow for an attached cable.  The rectangular tray below can hold many things including headphones, cases, keys, small tools, etc.  Behind the main supports, there is an additional vertical slot for holding things behind the phone or tablet (such as a pad of paper, pencils, etc.).  The back is designed to mounted in a variety of ways including screws to the wall, pegboard, and Ryobi Link wall storage system.

If mounting to the wall or Ryobi Link Wall Rails, the pegs stay recessed on the back and are not used. If mounting on pegboard with 1" (25.4mm) holes, pry pegs (with a small flat screwdriver) out and push into the holes. 2 curved pegs go into the top holes pointing upward and 2 straight pegs go into the bottom holes.  We recommend you superglue them into place. 2 extra pegs (one curved & one straight) are included.

No devices are included.  Any devices shown in photos are for reference only.  Some photos show wire clips in the horizontal channels of Ryobi Link Wall Rails which are sold separately (and are not included with this holder).

It is 3D-printed in black PLA plastic.  It is 3.6" x 3.3" x 4.8" (92mm x 85mm x 122mm).

PLA plastic which is made from a renewable resource. It’s biodegradable and eco-friendly. These are lightweight and due to the printing process, there may be some imperfections. 3D Printing involves the heating and depositing of material on a flat board one layer at a time. Each model is custom printed in the USA to order.