2-phase 4-wire Stepper Moto 90mm Linear Screw Slider 5V Pull Push Rod Actuator

Specifications:

Micro Sliding table fit for DIY laser engraving machine as its XY axis
Motor Type: 2 phase 4 wire
Driving Voltage: DC 4-9V / 500mA
Step Angle: 18 degrees
Screw Length: 90mm / 3.5"
Screw Diameter: 3mm / 0.1"
Slider Width: 15mm / 0.6"
Effective Stroke: 80mm / 3.1"
Screw Pitch: 0.5mm / 0.02"
Stage Size: 105 x 15mm / 4.31" x 0.59"
The speed of a straight line is the maximum 25mm/s
Blue A +, Black A-, Red B +, Yellow B-
 
Note that the stepper motor, direct power is not rotating, the need to stepper motor drive board and control panel.
 
Package Included:
1 x Drive Stepper Motor Screw With Nut Slider
 
We accept payment by PayPal only.
Payment must be received within 7 days after auctions ended.
Items will be shipped within 1-2 business days when we received payment.
Shipping to USA takes about 8-15 days in normal condition,other countries takes about 15-35 days.
Please verify your eBay primary shipping address. We are not responsible for any wrong or undeliverable addresses.
All items will be checked before packing
Your feedback and 5 star ratings are much appreciated.
If you are unhappy with your purchase, please contact us on negative / neutral feedback or low star ratings.
If you receive an item is damaged or defective, we will refund you or replace it with identical one.
All damaged or defective items may be exchanged within 30 days.
We take full responsibility if you receive wrong item or damaged item or item not as describled.
If you're not satisfied for any reason, please feel free to contact us.Just send us an eBay message.
PushAuction