HINGE/JIG - Hinge recessing Jig Single Piece
The single piece Contractor Hinge Jig is designed for recessing hinges in wooden doors & frames with a plunge router.
- It is easy to use with minimal setting-up time, completing the job both accurately & quickly.
- Used on-site & in joinery shops to increase productivity with excellent results.
- Four apertures for fire door requirements.
- No need for marking out in the conventional way.
- Quick & simple to set-up as the hinge is used as the pattern.
- Clean & accurate recesses are achieved every time. Suitable for timber based doors & square butt hinges.
- Can be used on both inside and outside doors, rebated frames and on maximum 25mm thick fixed stops.
- Use with a light duty plunge router with 1/4 inch collet.
- Long reach router cutter required, 12mm diameter with 70mm overall length.
- Angled position slots to prevent creep.
- Unibase may be needed.
- T4EK router requires a ref. UNIBASE or special guide bush ref. GB/T4/160.