This double-sided tape with acrylic adhesive is an incredibly strong and reliable model for a variety of uses indoors and outdoors.

 Specification

Thickness: 1mm

Tape: Acrylic Foam

Adhesive: Acrylic

Colour: Black

Rolls: 5 metres length

Tape Width: 20 mm

This double-sided tape can be easily cut with scissors to the length you need and is a perfect mounting tape for car, bike and vehicles for trim and number plate fixings. With a foam core, it can absorb movement so is suitable in projects where tolerance is required.

Very practical for attaching objects to tile, brick, laminated wood, metal, as well as cameras and dashcams. It's low-tack to the touch however once in contact with the appropriate surface this adhesive tape immediately starts to bond with full strength achieved after 24 hours cure time.

- Apply by cleaning the surface thoroughly with an alcohol-based cleanser and allowing to fully dry.

Press the tape onto surface firmly for at least 10+ seconds and unroll as required then cut from the roll, this is a pressure-sensitive tape which requires pressure to start the bonding process.

- The liner can be easily removed with a sharp point if it's proving difficult by hand.

- Poor adhesion is often the result of an unsuitable surface or traces of dirt and grease between the surface and tape contact. Acrylic tape is an excellent all-rounder and weather resistant.

- Note that to the touch this tape may not feel as sticky as you would expect, acrylic adhesive works by bonding over time to create a bond many times stronger than a rubber-based adhesive tape. It will stick to itself quickly so be careful when using.

Do not use it in very cold weather for outside sticking. In this case, you can heat the spot, before using the tape.

Removal leaves no residue or damage to the surface, it can be removed by hand or using a little direct heat while pulling it back. It is not recommended to re-use tape which has previously been applied.