OE BASS PACKAGE! INCLUDES SUBWOOFER/AMPLIFER/BOX/WIRING KIT! RRP £485 


12" OE SUPREME SERIES OE-S12.2 D2

  • 12 Inch Dual 2 Ohm Coil Configuration
  • High Strength Cast Aluminium frame
  • 3 Inch - 4 Layer High-Temperature Copper Voice Coil
  • 200 Oz Y35 Graded Dual Stacked Ferrite Magnet With Rubber Magnet Boot
  • Non-press Paper Cone With Tall Foam Surround
  • PC Blend Spider Pack
  • Advanced Air-Cooling System
  • Round Weaved Copper Tinsel Leads
  • Strong Dust Cap
  • Magnet Weight: 200Oz 
  • Voice Coil: 3” 2ohm+2ohm
  • RMS Power: 1600W
  • Max Power: 3600W
  • Freq. Response: 35Hz- 300Hz
  • Sensitivity: 85dB


Hifonics Zeus Theta ZTH-1525.1D mono block amplifier 

Description:

Low Noise Preamplifier Circuit
Maximum low voltage signal from the source unit comes into the amplifier circuit with minimal distortion.

RCA Inputs
Nickel plated high temperature impact resistant with hex screw terminals that allow for secure connections and is erosion resistant.

High Level Inputs
Easily tie into OEM audio systems that do not offer RCA output to maximize after market amplifier power.

Operation Mode
Four Channel, Full Range, Bridgeable: Flexible installation allows this amplifier to run in four channel or bridged mono mode.

Crossover Type
Onboard electronic crossover

Electronic Equalizer
Control of amplifier output with on-board electronic crossover to tailor specific frequencies to speakers and subwoofers.

Class / Topology
Class D: High efficiency with big power in a small footprint.

Output Device Technology
PWM MOSFET Power Supply: Stable power through the PC board with minimal heat generation.

Heat Sink
Aluminum: Old School Hifonics Heat sink for Superior Heat Dissipation.

Power Supply
Simpatico Coil Design: The dual coil Pulse Width Modulated power supply keeps voltage constant through the Ultra-Fi output devices.

Connection Type
Secure molded connection terminal for all Power, Ground and Speaker connections. Angled for ease of access while creating a clean wire management profile.

LED System Protection Circuitry Diagnostics
Monitor overload and speaker short protection with illuminated indicators on the amplifier end panel.

Specifications:

  • Amp Class: Class D
  • Amp Total Channels: 1
  • Amp Max Power (watts): 1500
  • Amp Power @ 1 Ohm (ch x watts): 1 x 1500
  • Amp Power @ 2 Ohms (ch x watts): 1 x 750
  • Amp Power @ 4 Ohms (ch x watts): 1 x 375
  • Amp Crossover: Variable Electronic 12dB Per Octave
  • Amp Variable Low Pass Crossover 12dB per Octave: 40Hz-300Hz
  • Amp Tone Control / Parametric EQ: Built-in bass control
  • Amp Bass Boost: 0-9dB
  • Amp Subsonic Filter: 10Hz-40Hz
  • Amp Variable Voltage: 0.2-6V
  • Amp Frequency Response: 10Hz-500Hz
  • Amp Total Harmonic Distortion (THD): < 0.1%
  • Amp Speaker Level Audio Inputs - Yes

    • Subwoofer Enclosure:

    • Built-in Terminal with Gold Screw Posts
    • Constructed with High Quality MDF Hardwood
    • 15mm MDF Face
    • Enclosure Volume is 1.25 Cubic Feet
    • Height 34cm x Length 41cm x Top Depth 22cm x Bottom Depth 29cm
    • Speaker Mounting Depth is 245mm
    • The Front (where the woofers loaded) is flat and the Back is Slanted
    • Only the Best Black Aviation Carpet
    8 AWG WIRING KIT

    This kit consists of the following items:

    4.9m red soft jacket pre terminated power cable w/fuse holder

    0.9m black soft jacket pre terminated earth cable

    5m blue remote cable 5m soft jacket Double shielded RCA cable

    5m double shielded high-quality flexible RCA cable

    5m 18 awg Speaker wire

    2 x fork terminals

    1 x 60a Fuse