Specifications:
- Model: JGY370 Gear Motor
- Rated Voltage: DC 6V/12V/24V
- Speed: 6rpm, 10rpm, 18rpm, 23rpm, 30rpm, 40rpm, 55rpm, 66rpm, 90rpm, 150rpm
- Shaft diameter: 6mm
- Shaft length: 50mm
- Scope of application: smart car, smart home, range hood, crane machine, etc.
Features:
- Metal material
The use of all metal materials makes it more wear-resistant, rust resistant, corrosion-resistant, and has excellent thermal conductivity. It has a larger hardness, durability, strong power, long service life, low loss, and low heat generation.
- High quality gears
After gear grinding and heat treatment, it has good wear resistance, long service life, and higher performance. It uses silent lubricating oil to ensure that the motor shaft runs quietly for a long time, effectively reducing bearing vibration values, rust prevention, and corrosion resistance.
- High quality carbon brushes
Carbon brush structure replaces copper brush, with long service life, low friction, low power consumption, slow temperature rise, stainless steel material output shaft, high-precision mechanism, smooth operation, and more silent.
Precautions for motor use:
1. Before use, confirm that the motor voltage is correct, and if it is a DC motor, confirm whether the power supply current is sufficient
2. Can not be overloaded, the reason for overload is mainly divided into two parts, torque and shaft force, load torque can not exceed the rated torque of the motor, the force of the shaft can not exceed the axial and radial allowable force of the shaft, the measured current of the motor after the load can not exceed the rated current, the general motor must be equipped with a fuse to avoid overload and burn the motor
3. Do not store or operate in a high temperature or humid environment, and do not place it in corrosive gas, which will reduce the effect of the motor
4. When assembling transmission parts such as gears and pulleys on the motor shaft, do not knock abnormally when pressing
5. When soldering is to be made on the motor terminals of the positive and negative poles of the power supply, the temperature of the soldering iron is 340 °C± 40 °C, and the heating time is less than 3 seconds, so that the plastic can not be deformed
6. When installing the motor, pay attention to whether the screws are too long, and prevent the screws from being too long to press the parts in the motor