Specifications:
Motor Model: JGA25-310
Power Supply: DC 6V 12V
Shaft length: 12mm
D-shaped shaft length: 8mm
Shaft diameter: 4mm
Speed:
6V: 8RPM / 10RPM / 17RPM / 23RPM / 39RPM / 50RPM / 85RPM / 110RPM / 180RPM / 400RPM / 900RPM
12V: 16RPM / 21RPM / 35RPM / 46RPM / 77RPM / 100RPM / 177RPM / 220RPM / 375RPM / 830RPM / 1800RPM
Features:
- Copper windings
The rotor part is made of pure copper, with low resistance and strong conductivity, which increases the motor torque.
- Metal gear structure
All metal gears effectively enhance the torque of the motor, making it more wear-resistant, rust free, and extend its service life.
- D type shaft
D-shaped output shaft increases force friction and increases motor torque.
Applications: Instruments, digital products, medical devices, vending machines, paper dispensers.
Motor precautions:
1. When you use the motor, there should be no restraints, such as the adhesive should not flow into the bearing through the rotating shaft, which will hinder the operation of the motor.
2. The rotation of the shaft may have the opposite effect on the life of the motor, in order to prolong the life, please check whether your load is in accordance with the regulations, and should not be overloaded or the shaft end is hung with items that hinder the rotation.
3. Manufacture into eccentric heavy radiation loads, harmful to the life of the motor.
4. Do not store in the surrounding high temperature or extreme humidity, and do not place it in corrosive gas, which will reduce the effect of the motor.
5. Do not run the motor in the surrounding high temperature and humidity.
6. When soldering on the motor terminals of the positive and negative poles of the power supply, the temperature of the soldering iron is 340 °C ± 40 °C, and the heating time is less than 3 seconds, so that the plastic should not be deformed, and the solder point will flow into the motor or break the end of the wire during the work, which will make the motor function decline.
7. Do not let the motor shaft get stuck, when the power is incoming, it will overheat the motor in a short time and burn its accessories.
8. Due to the lack of technology of the staff, the quality of the motor cannot be guaranteed when it encounters the things mentioned in the manual, or when the apparent judgment is obviously negligence.
9. Supply the specified electricity, and be sure that it is within the range of measurable requirements.
10. The installation of pulleys or gears should not be abnormally aggravated when pressed.
11. When installing the motor, if the screws are too long, there will be contact between the motor itself and the rotor, which will affect the characteristics.