Voltage Regulator for Kawasaki Ninja EX 250 500 | Vulcan 500 EN 450 / 500 | Eliminator 250 | KLE500 1972-2009 21066-1030

KEY FEATURES
 

Plug-and-play, direct fit, easy installation

Higher grade of electric components

The quality exceeds the OEM equipment

Improved heat sink and charging capabilities

All products shipped are tested

DESCRIPTION

 

Battery condition is important. No regulator can make up for a bad or weak battery. If in doubt charge your battery and have it load tested, or simply replace it. ALWAYS START WITH A FULLY CHARGED BATTERY !

Brand new aftermarket Voltage Regulator Rectifier

  • Direct replacement to your original unit.
  • Plug-and-play, direct fit, easy installation.
  • No assembly required
  • Higher grade of electric components.
  • Improved heat sink and charging capabilities
  • The quality exceeds the OEM equipment
  • All products shipped are tested

We have even included the opposite connector (main harness side) as we know these are often melted / corroded / defective and are a major cause of repetitive electrical issues.

All item pictures are accurate, if in doubt, do not hesitate and compare our item to your original part.

Vehicle models fitment

 

Kawasaki EL 250 Eliminator -- 1988-1994, 1996-1997, 1999, 2001, 2003
Kawasaki EL 252 Eliminator -- 1996-1997, 1999, 2001, 2003
Kawasaki H2C Mach IV Carb F/C -- 1972-1975
Kawasaki KLE 500 -- 1991-1997, 1999, 2001-2007
Kawasaki KZ 550 -- 1980-1983
Kawasaki KZ 550 GPZ -- 1982-1983
Kawasaki KZ 550 LTD -- 1980-1984
Kawasaki KZ 550 Spectre -- 1983
Kawasaki KZ 750 LTD -- 1983
Kawasaki KZ 750 Spectre -- 1982-1983
Kawasaki Ninja 250 R -- 1986-1990, 1992-2007
Kawasaki Ninja 500 EX500 -- 1987-2003
Kawasaki Ninja 500 R -- 2004-2009
Kawasaki Vulcan 454 EN450 -- 1985-1990
Kawasaki Vulcan 500 EN500 -- 1990-2009

OEM part replacement

 

21066-1030
21066-1028

Specifications

 

Dimensions:
Width: 78 mm
Length: 80 mm
Height: 32 mm
Wires length: 170 mm
Fixation holes center to center: 60 mm

Other specifications:
Number of plugs: 1
Number of pins: 6
Number of wires: 6
Minimum Charging Voltage: 14.5 V +- 0.5 V
Maximum Charging Current: 50 A / 500 W
Open Circuit Voltage: 15 V
Operation Temperature: -20? to 85?

instructions

 

Before installing your new Voltage Regulator Rectifier:

  • Check the AC output of the stator.
  • Replace any burned or corroded connectors on stator and regulator rectifier.
  • Check and repair any melted wiring.
  • Use hi-temp dielectric grease on all connectors.