HRC64 HSS-Co-M35 Metric Serial Tap Set M3 M4 M5 M6 M8 M10 M12 Right Hand Thread Cutter Machine Taps For Stainless Steel

The Taps is made of HSS-Co-M35, which rockwell hardness is up to HRC68, and excellent for tapping tough metals such as stainless steel.

Specifications:
Material: HSS-Co-M35(5% Co High Speed Steel)
Rockwell Hardness: HRC64-68(Excellent for tapping tough metals such as stainless steel.)
Size: M3,M4,M5,M6,M8,M10,M12,M14
M3: 3mm x 0.5mm (Pitch)
M4: 4mm x 0.7mm (Pitch)
M5: 5mm x 0.8mm (Pitch)
M6: 6mm x 1.0mm (Pitch)
M8: 8mm x 1.25mm (Pitch)
M10: 10mm x 1.25mm (Pitch)
M12: 12mm x 1.5mm (Pitch)
M14: 14mm x 2.0mm (Pitch)
Thread Direction: Right Hand

Quantity: 1Pc.

How to use it？
To start cutting inside threads lube your hole with cutting oil and start the Rougher tap with lots of taper run this tap about 2 or 3 turns in then back it out 1/4 turn lube your work go another 2 or 3 turns back it out 1/4 turn keeping your work wet with cutting fluid continue this method until you have completed the cut then use Intermediate tap the tap with the 2nd least amount of taper run this tap through using the same method as above then your final cut is with the Finisher tap.

Care in tapping:
Considerable care must be execised when tapping.
Use the tap before the die because the tap are non-adjustdable for size, the dies are.
Start the tap square.
Use a cutting solution where necessary.