Step 1: Print Image

Create and print your design with an inkjet printer. Let it dry for a while.

Step 2: Spray Acrylic Coating

Seal the print image with the clear acrylic spray. Spray 3 even coatings over the image allowing each coating to dry then spray again. Wait for it to dry completely.

Tips: The ink will dissolve in water if the coating is not sprayed evenly.

Step 3: Cut Out Image

Use scissors to cut out the image. Leave a border of 3 mm around the design for best results.

Step 4: Soak In Water

Soak the deal in room temperature water for about 30~60 seconds or until the paper backing can slide easily. Take out the decal from the water.

Step 5: Slide

Place the decal onto the desired surface with the image side facing up. Gently hold the edge of the decal while sliding off the backing sheet.

Tips: Put some water on the surface for easier sliding.

Step 6: Smooth and Dry

Use a paper towel or mini squeegee to remove air bubbles and excess water out from behind the decal.

Then let it sit to dry by nature.

Tips: Ceramics can be baked in an oven at 230℉ for 10-15 minutes for more strong adhesion.

Extra coat of epoxy resin can be used on the finished decal for more protection.