The Overland Electronics OE-SLPOE01 is a custom high power PoE injector that connects to your Starlink using modified wiring and allows you to use a 48V or 56V DC power supply to power your Dishy using power over ethernet (PoE) injection instead of the supplied/OEM AC power supply. The OE-SLPOE01 is compatible with Starlink’s 1st Generation “round” Dishy (power input 56 VDC) or 2nd Generation “square” Dishy (power input 48 VDC). Using the OE-SLPOE01 with your Starlink Dishy instead of the bundled OEM AC power supply can save you up to 30% of of your Dishy’s total power consumption if you are running your Starlink Dishy off a DC power source by eliminating the energy that’s typically lost in AC to DC power inversion. The OE-SLPOE01 also frees you to use your own router and networking equipment with your Starlink Dishy and the compact design of our device can save space and opens up a range of mounting options that simply aren’t possible with the bulky OEM AC power supply and router.

Included

1x OE-SLPOE01

2x RJ-45 connectors

1x Fuse (Preinstalled)

Not included

Crimping tool (needed for Round Dishy)

48 or 56V DC voltage source

Network Device (Router)

Ethernet Cable (cat5/5e/6/7)

Starlink Hardware

Boost Converter (Most RVs, vehicles and boats 12V to 48 or 56V)

Screws or double sided tape (for mounting)

Flathead Screwdriver

Technical Information

This PoE injector is designed to inject voltage over all conductors: (1 2 3 6 for +VE and 4 5 7 8 for -VE). This pinout is common to both 1st Generation “round” and 2nd Generation “square” Dishy.

Networking

Supported standards: LAN 10/100/1000 Base-T

Connector termination: T-568B (W/O, O, W/G, B, W/B, G, W/Br, Br)

PoE pins: 1 2 3 6 for +VE and 4 5 7 8 for -VE.

Electrical

Input Voltage (Not Supplied)

56V for 1st Generation “round” Dishy

48V for 2nd Generation “square” Dishy

Current Consumption (Max): 2A

Voltage Drop: 85mV / 0.085V (Tested using 48V@1A)

Protection: Built in high efficiency reverse polarity protection

Additional notes

Designed purely for Starlink Dishy 1st Generation (Round) and 2nd Generation (Rectangular).

Shield and voltage ground lines are not connected by default. Jumper pads (JMP1) on a board can be shorted to connect shield and ground.