ULTRA LIGHT BLACK 70% LIGHT TRANSMISSION 30% DARKER
TINT
2 x ROLL 3m x 76cm (9'10" x 2'6")
-Tint individual windows on cars, campers, vans and boats, conservatories houses, any other
buildings...
-Tint rear windows in your vehicle to protect pets from sunlight.
-Use as a security measure to conceal contents of your van or boot space.
-Darken the car interior for clearer viewing of rear DVD screens.
-Prevents windows from shattering in event of an accident.
-Increase Comfort - The film reflects the sun's heat.
-Protects Your Vehicle - The films UV radiation blocking action slows down fading of interior fabrics
and plastics, helping to keep your vehicle interior looking new for years. Enhances Vehicle Appearance
-Reduce glare - enhance driving safety
OTHER
FILMS' TYPES AVAILABLE
ULTRA SUPER DARK BLACK 1% LIGHT TRANSMISSION 99% DARKER TINT
SUPER DARK BLACK 5% LIGHT TRANSMISSION 95% DARKER TINT
DARK BLACK 15% LIGHT TRANSMISSION 85% DARKER TINT
MEDIUM BLACK 25% LIGHT TRANSMISSION 75% DARKER TINT
LIGHT BLACK 40% LIGHT TRANSMISSION 60% DARKER TINT
ULTRA LIGHT BLACK 70% LIGHT TRANSMISSION 30% DARKER TINT
SILVER 15% LIGHT TRANSMISSION 85% DARKER TINT
FITTING INSTRUCTION:
IMPORTANT:
The film must be separated from its transparent protective layer
this is best done with 2 small pieces of scotch/adhesive tape/ sticked
on both sides of one of the corners of the film and this will reveal its adhesive side,
please apply it on your window with plenty of soapy water on the glass,
then press with the plastic tool (to avoid scratching the film please
do not press too hard with the plastic tool or better wrap it in some cloth).
Thanks
1. Clean window inside and out with soapy water. NO AMMONIA
2. Cut film pattern on outside of glass. LINEAR SHOULD FACE OUTSIDE
3. Trim film to fit on outside of window
4. Spray a light film of water on glass and film
5. Peel film apart from backing on inside of window. Use two pieces of transparent tape to separate film from liner
6. Spray adhesive with soapy water solution
7. Place film on INSIDE of window
8. Spray film with soapy water solution and squeegee firmly
9. Trim film with new sharp blade, leaving 1/16” gap around edges
10. Spray film with soapy water solution and squeegee firmly
11. Drying time 3 days in full sun
The United Kingdom sets minimum light level requirements for vehicle window tint. Please make sure you follow these requirements: https://www.gov.uk/tinted-vehicle-window-rules