OUR FILM MEASURES: 76CM X 3M

IMPORTANT:

 the film must be separated from its transparent protective layer this is best done with 2 small pieces of scotch/adhesive tape/ sticked on both sides of one of the corners of the film and this will reveal its adhesive side, please apply it on your window with plenty of soapy water on the glass, then press with the plastic tool (to avoid scratching the film please do not press too hard with the plastic tool or better wrap it in some cloth). Thanks  

•  20% SILVER/CHROME REFLECTIVE TINT FILM

SUPPLIED WITH OUR KITS:            

 -FITTING TOOL

 -PLASTIC SQUEEGEE

 FITTING INSTRUCTION:

Fitting Instructions:

1. Clean window inside and out with soapy water. NO AMMONIA 

2. Measure the window. 

3. Place film on flat surface and mark the size you need to cut, add extra so you may trim to size later. Using scissors cut the film. 

4. Peel film apart, using two pieces of tape to separate film from transparent protective layer with 2 small pieces of adhesive tape, stick on each side of one corner and this will reveal its adhesive side.

3. Spray water on adhesive side of film and spray plenty of water on glass window.

4. Place film onto interior side of window. 

5. Spray film with water and press firmly with plastic squeegee tool, avoid scratching the film, do not press too hard! or you wrap it in some cloth. 

6. Once film is pressed cleanly onto glass window, trim film with new fitting tool, leaving 1/16” gap around edges. 

7. Spray film with water again if needed and squeegee firmly. 

8. Drying time 3 days in full sun.