New 3D printed Pioneer SX-950 / SX-1250 / etc. AM antenna mount.  We have two receivers where these mounts were broken so we whipped up a few new mounts on the 3D printer.  They worked better than expected so we made a few more in case someone else needed one. 

These are a much simpler design than the factory mount.  The base mounts flush with the back panel and does not stick inside.  There is no spring, instead the ball pivot snaps in with some force and friction holds it at the desired position.  We only really wanted it to keep the antenna in place without it flopping around the back of the receiver, it's not like we move the AM antenna around a lot.  See pictures and installation shots on an SX-950.  We used an SX-1250 base and ball pivot as templates, so I am certain it works with that model too.  We took a close look at an SX-1010 and it certainly looks the same as the 950 and 1250, but we didn't try installing one because it wasn't broken and we didn't want to anger it.

We've been told that the following units use the same mount, but we can not completely verify this ourselves:
QX 949
QX 9900
SX 828  (verified)
SX 1010   (visually verified)
SX 950   (verified)
SX 1050   (visually verified/5580)
SX 1250  (verified)
TX 800
TX 1000 (customer verified)
TX 8100
TX 9100
TX 9500

Please try to verify compatibility with your particular model.

Sale is for the base only.  The ball pivot, AM antenna rod, wires, SX-950, etc. are not included.

Shipping is USPS First Class.  Weight is under 2oz. so it should be cheap. 

Thanks for looking!