BATTERY LIFE ENHANCER 

battery desulfater

Save Your Hard Earn Money

 The battery life enhancer reduces the frequency of battery change Battery loose life span even before use!

 

 Battery Life Enhancer when connected cleans the electrodes & keeps it in cleaned state thereby saving the extra electricity charges required to overcome the corrosion problem.

 

 Save the Green Earth! Reducing the ratio of battery disposal means fewer disposals of hazardous Lead & Sulfuric acid. 

Increase the service life of Battery. 

 

The DELTA battery Life Enhancer generates an electrical pulse that shatters & removes lead sulfate crystals maximizing its life-span & performance.

 

 

Why this Device needed?

 

75% to 80% of lead acid batteries fail prematurely because of formation of lead sulfate on the plates. 

 

These crystals cause batteries to become unusable at approximately one-third of their natural life.

 

How does it Works?

Using break through square wave technology. PBLE electronic device sends a frequency signal to each crystal of lead sulfate, causing it to dissolve into sulfuric acid. 
This restores the battery to its original condition & allows the maximum efficiency electrical charge to be drawn from the battery.





Prevent lead sulfate crystallization in new batteries. Prevent damage to lead plates due to lead sulfate





 crystal buildup. Due to sulfation, charging time increases so the electric bill increases & output decreases.





 With the help of PBLE charging time remains same as per new battery & saves money through electricity & 





output increases.









“How you will be benefited”

 

One PBLE can rejuvenate a number of batteries connected in parallel, if the total voltage & ampere-hour 





ratings are suitable to the units. Battery life enhancer products are epoxy-moulded, shock-





resistant & waterproof & can withstand high ambient temperature. 





Our PBLE generates an electrical pulse that shatters & removes lead sulfate crystals maximizing its life-





span & performance.













 

 

APPLICATIONS:

·          

·         Automotive Batteries.

·          

·         Solar farm storage systems.

·          

·         Back-up system Battery Banks (12v only).

·          

·         Marine Batteries.

·          

·         DC system of electrical substation.

·          

·         Telecommunication hubs.

·          

·         UPS Battery Banks.

·          

·         Truck Batteries.

·          

·         Electrical cars & scooters.

·          

·         Wind farm storage system.

·          

·         DC starting system.

·          

·         Inverter Batteries

·          

·         All automotive Batteries

 

 

Caution:

 

This product can not revive absolutely dead battery

 

1. What causes a lead acid battery to go bad?

The most common cause of premature battery failure...

Is due to a build-up of sulfate on the plates, which interferes with the charging and discharging of the battery. This build-up is accelerated by the following:

• high temperature -- over 70 degrees;

• discharging the battery below 10.5 volts;

• storage without charging

The best way to prevent and remove this build-up is to use a DELTA Battery Life Enhancer.

The second most common cause of premature failure...

Is loss of electrolyte --(the liquid chemical that causes electricity to flow) --due to overcharging or heat.

The third most common cause of premature failure...

Is undercharging because undercharging accelerates the build-up on the plates.

Use DELTA Battery Life Enhancer to over come this problem.

The fourth most common cause of premature failure...

Is called "old age." This is a result of the plates shedding material which falls to the bottom of the battery cell and eventually shorts the plates. This shedding of material is accelerated by the buildup mentioned above.

The answer to longer battery life is DELTA Battery Life Enhancer.

The fifth most common cause of premature failure...

Is excessive vibration. This causes the shedding to occur faster. The DELTA Battery Life Enhancer electronic device can help here because clean plates will shed more slowly.

 

2. What can I do to prolong its life?

• Perform regular maintenance, especially during hot weather as follows:

• Check the electrolyte level in your battery.

• Clean the battery top to eliminate conductive paths so electricity is not re-routed and wasted.

• Check the battery voltage and recharge if necessary.

• After deep cycle discharges or jump starts, recharge your battery.

• Use a DELTA Battery Life Enhancer —just attach it to your battery in seconds and forget about it.





3. How does the DELTA Battery Life Enhancer work?

It works by emitting a radio frequency signal that dissolves the build-up that forms on the plates of the battery.

If you are technically inclined and want more information, see the How Battery Works page.





4. If I have more than one battery in my vehicle do I need to buy more than one DELTA Battery Life Enhancer?

You only need one DELTA Battery Life Enhancer.

It is powerful enough to rejuvenate all the batteries at once.

If your batteries are hooked in parallel, just hook the red wire from PBLE to the positive output and hook the black wire to the negative output.

If your batteries are hooked in series, as in a golf cart or other electric vehicle, then you will need a DELTA Battery Life Enhancer that is rated for the total voltage of all the batteries linked together.





5. Do I need a separate PBLE for each of the cars in my family?

The best way to use DELTA Battery Life Enhancer is to use one on each car.

The DELTA Battery Life Enhancer is designed specifically to keep one car battery in like new condition if it is attached permanently. By using DELTA Battery Life Enhancer in this way, you can be sure you or a loved one will not be stranded by battery failure.





6. How do I use DELTA Battery Life Enhancer electronic device?

Just like Jumper Cables, the DELTA Battery Life Enhancer electronic device come with two leads, one red and one black.

In applications using multiple batteries, connect the red lead to the positive terminal of the first battery, and the black lead to the negative terminal of the last battery, and forget it!