IMPORTANT

WE MAKE TWO SIZES IN THE YAMAHA TRIM-WRENCH PLEASE CHECK THESE MEASUREMENTS FOR A SURE FIT.

SEE DIAGRAM

 THIS TRIM WRENCH WILL FIT THE TRIM ROD CAP THAT HAS 5/32 DIAMETER HOLES WITH A CENTER TO CENTER DISTANCE OF ( 1 1/2" OR 1.500 ) 

TRIM WRENCH

THIS WRENCH WAS DESIGNED TO SOLVE THE PROBLEM OF REMOVING THE ALUMINUM CAP FROM THE YAMAHA TRIM ROD ASSEMBLY WITHOUT DESTROYING IT .  THE CAP HAS FOUR HOLES AND IT MAKES MORE SENSE TO USE ALL FOUR HOLES WHEN REPLACEMENT IS NEEDED, RATHER THAN TWO LIKE MOST SPANNER WRENCHES.

 

TRIM WRENCH IS MADE OF STEEL WITH A BLACK OXIDE FINISH. THE PIN ASSEMBLY IS MADE UP OF A 5/16-24  HEAT TREATED ALLEN CAP SCREW AND HAS A 5/32 DOWEL PIN PRESSED INTO THE BODY.  THIS ASSEMBLY DESIGN ALLOWS YOU TO REPLACE A PIN IF DAMAGED BY UNSCREWING THE CAP-SCREW AND REPLACING IT WITH A NEW ONE WHICH ARE AVAILABLE THROUGH OUR STORE...... MOTO-STOP-SHOP AT $5.45 EA.

THANK YOU, MIKE

PLEASE EMAIL ANY QUESTIONS OR COMMENTS ABOUT THIS ITEM.

     ALL OF OUR PRODUCTS ARE FULLY GUARANTEED AND MADE IN THE USA