I offer:

A pair (4 pieces + glue) of high quality foam speaker surrounds - they can replace the deteriorated foam surrounds in your Infinity Reference 40 cabinet.

This kit contains:

  • Two 8 inch rings to repair the woofers
  • Two 4,5 inch rings to repair the midranges
  • Enough glue to attach all the rings
With this kit you will be able to give your Infinity speaker a new 20-30 years of life.

Here's the tool to fix the rotten surrounds, these rings are made of foam! 

Replacing a surround is not that hard - it's a job that needs your full attention but then everything will work out just fine. If you are in doubt, or have any questions - don't be affraid to ask. Any question about refoaming can be asked. We havee a FAQ, refoam manuals, our video instructions and much more online on our website! Ask for the URL.


about the glue for foam surrounds - 18 cc (you will receive one bottle)

General
Special water-based, permanent-flexible adhesive for bonding foam surrounds on speakercone and frame. This bottle contains 18 cc glue.

One bottle is enough adhesive for:
- 2 twelve-inch surrounds, or
- 4 eight inch surrounds, or
- 8 four inch surrounds

Storage
This is a water based adhesive. Keep the adhesive in a frost-free room.

Processing
Surface must be flat, dry, and free dust and grease. Apply the glue with brush or roller. The Elastic adhesive dries relatively quickly. If thicker layers are applied, or the adhesive is used with less porous materials , the drying time will be significantly longer. The glue is dry when the color is transparent and the original white is gone. The adhesive can be applied both single- and double-sided. For a higher final strength and longer drying / processing time we recommend to apply the glue doublesided. Remove wet glue immediately with a wet cloth, dried adhesive residue can be removed mechanically. Clean tools immediately after use with water.

Features:
Base: acrylic dispersion
Solids content: about 60%
Density: approximately 1 g / cm ³
Viscosity about 5000 mPa's
25 °C pH value: 5.5
Min. processing temperature (MFT): 10 ° C
Wet color: white
Dry color: transparent
Odor: odorless (slightly acidic)
Number of components: 1
Temperature resistance (dried): -40 ° C to +160 ° C
Moisture resistance: good (if applied doublesided)
Open time: infinite - lasting tack
Drying time: Depending on the circumstances of 30 minutes to 2 hours.
Consumption: 250 g / m²

Safety sheet
In case of problems we have a safety sheet available (Dutch language).

I will pack the surrounds very well so they will reach you just fine. Beside these surrounds I also have foam versions and I have hundreds of other sizes available. Check my Ebay shop or contact me.