-There is no painting in this exhaust, Rust can come out over time, "solution" you applies high heat paint.
-This exhaust will change color due to the high heat generated by the engine.
Please look at
all the pictures to know if it will work on your application, compare
all the measurements using a measuring tape to make sure it does not hit the fender or frame. Type of material: mild steel, Uncoated Steel.
- 2 Lock washer and 2 nut included.
*Gasket & Engine not included.
Good for: ... multipurpose.
Weighs about: 12oz
This been tested on 212cc (6.5hp) Predator Hemi 212cc, Honda GX160, GX200, also tested on Powerhorse 208cc, DuroMax 7 Hp (no tested on otherengine)
I think it worksin all whoareHondaclone.pleasecheckthe measurements of yourenginebefore you buy. center hollow to hollow 1" 13/16 (see photosfor details) Exhaust pipe Madein U.S.A. We only ship to paypal confirmed address.
Florida residentspay 7%taxes.
Finding the Correct Pipe Thread Size
National Pipe Threads (NPT)
Pipe sizes do refer to physical dimensions, but the plumbing industry
standard for the sizes of pipe is not always as straight-forward as
measuring the pipe. Measuring the pipe will oftentimes mislead you into choosing the wrong pipe, so do take care.
The "pipe thread size" as shown in column 3 of the table below is
measured and based on the inside of the pipe. But, to actually determine
the size of a pipe, the outside diameter of each pipe or fitting must
be measured and compared to the table for size identification. For
example, a 3/4" NPT pipe thread has an outside diameter of 1.050 inches.
Each thread size has a defined number of threads per inch (TPI). The
3/4" NPT pipe thread has 14 threads per inch. Both the TPI (threads per
inch) and OD (outside diameter) of the thread are required for positive
identification of thread size because several sizes have the same TPI.