One GolfWorks Grip Rib Pack – 30 Ribs per Pack - Make any Grip Ribbed
Brand New
Features
· Grip ribs ensure consistent hand placement on every club
· Rib can be placed at any position on the shaft allowing for strong, neutral or week grip positions
· Grip logos can be positioned up or down with rib installed
· .035" thickness is close to but not exceeding USGA limit of .040"
· Rib can be installed in any rubber/cord, undersize, standard and oversize grip.
· Much easier to install correctly vs. ribbed grips
· 30 ribs per pak
· Alignment plugs included
The GolfWorks Rib Pack allows you to correctly align and
easily install a rib inside any golf grip creating a “reminder” that will
guarantee correct and consistent hand placement on every club in your bag.
Pre-installing the rib onto the golf shaft allows for the grip logo to be
installed in any position (logo up or logo down) depending on the golfers
preference. Each rib is .035” thick which is slightly less than the USGA .040”
maximum allowable rib thickness. Two alignment plugs, one for steel and one for
graphite shafts, are included in pack to eliminate the chance of miss-aligning
the rib during installation. Simply set the face angle into the required
position while inserted into a grip clamp and install the plug with the center
alignment stripe at 90º. Once the alignment plug is installed simply rotate the
club 180º in the grip clamp until the alignment strip is again at 90º. Peel the
paper from the back of the rib to expose the adhesive and attach the rib onto
the butt end of the golf shaft. Each rib features a printed alignment line to
further ensure the rib is installed correctly. Each rib is .035” thick, .25”
wide and 9” in length. Each Rib Pack contains two alignment plugs and 30
individual golf grip ribs.