20AX2 / 40Ax2 Brushless ESC Dual two-way mixed control RC Boat tanks 2S-4S Lipo
Parameters:
Two-way Blushless Mixed Control Electric Tuning
20A parameter
Voltage: 7.4-16.8V (adapted to 2-4S lithium)
Each continuous current: 20A, instantaneous current: 30A (10 seconds)
40A parameter
Voltage: 7.4-25.2V (adapted to 2-6S lithium)
Each continuous current: 40A, instantaneous current: 60A
BEC: Efficient DC-DC solution, 5V 2-3A (can be 2A long-distance running, no other UBEC insertion on the receiver, if 3A is not enough, contact the shopkeeper)
Overheat protection
Out of control protection (loss of signal for 1 second, motor shutdown)
The method of use is the same as the brush double mixed electric adjustment in our shop. The middle point of the throttle is electrically mediated.
(If the motor turns slightly after unlocking, please use remote control throttle/direction fine-tuning to stop the motor)
According to the open source firmware tips, when debugging, you must not take an oar! (Keep the oars in the cage at all times and keep your body absolutely safe)
There are two modes
Mixed control mode (default) (throttle/steering mode): 2 or 3 channels (recommended 2 channels, because 2 channels return automatically) control throttle, 1 channel (or 4 channels) control differential steering, throttle ratio 100%, steering ratio 100%, steering priority. Suitable for: Tanks (in this mode, Three Channels control can play with tanks), speed difference ships,
Two-way synchronization (single yellow line suspended): In this mode, two motors are synchronized by throttle control.
Main points of debugging:
First determine the direction of forward and backward motor. (That is, no single yellow wire is inserted to determine whether the positive or negative of the motor is OK)
Then adjust the direction (insert a single yellow line), if not in line with expectations, it may be that the remote control is reversed, set back.
Someone asked: not with out-of-control protection, why do I turn off the motor?
This is because when you turn off the receiver will output a low throttle signal. Low throttle is backward for power regulation, and full speed backward.
After shutdown, the receiver automatically outputs low throttle signal, also known as out-of-control protection.
There are three solutions
1) The throttle is connected to 2 channels, and the 2 channels out of control protection is generally 1 500 (if not, please set up), indicating stop.
2) According to the standard process, switch off the model power supply before the remote control power supply.
3) If you use 3 channels, set the 3 channels out of control protection to 1500
Important Reminder: The out-of-control protection of throttle passage (generally: 2/3 passage) is set to 1500, 1500 is stopped for two-way electric regulation.