APPLICATION:

 

For 2005 Ford Excursion US models only

for 2005-2007 Ford F-250 Super Duty

for 2005-2007 Ford F-350 Super Duty

for 2005-2007 Ford F-450 Super Duty

for 2005-2007 Ford F-550 Super Duty

Do not fit with the Sealed Beam Headlight model

FEATURE:

 

Black Housing Clear Lens

Made of materials that meet or exceed OEM requirements

Great Replacement or upgrade for factory headlights

Adjustment screws for high/low beam

 

 

PACKAGE INCLUDES:

 

1 Pair LH (Driver Side) + RH (Passenger Side) Headlights

INSTALLATION GUIDE:

 

Before you begin to adjust the light, make sure to check the alignment of your lights first. Park the vehicle about 10 to 25 feet from the wall with the lights aimed at the wall. The centerlines of the headlights should not be any higher than 3.5 feet above the ground.

1. Find the adjustment screws. Firstly, locate the adjustment screws on your vehicle.

2. Adjust the headlights individually. The headlights should be adjusted one at a time. Put a rag or towel over a chair in front of the light you want to block. Covering the light assembly directly can damage the plastic lens.

3. Adjust the vertical field. The screw on the top of the light housing should be turned clockwise to raise the lights and counterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the light beam shines directly on or just below the center of the tape line on the wall.

4. Adjust the horizontal field. The screw on the side of the light housing should be turned to get the right/left adjustment correct. Adjust the lens so that the most intense part of the beam is to the right of the vertical line.

5. Test your results.