You must know this before you make your purchase!
-This muffler is a little more Loud than the factory.
-There is no painting in this exhaust, Rust can come out over time, "solution" you applies high heat paint.
-This exhaust will change color due to the high heat generated by the engine.
"""For Mud Motor. (see photos for details)
Note:This Exhaust With Muffler does not have any kind of paint.
Included,
2 nuts, 2 washers, Gasket, Muffler, Exaust pipe 3/4 with Female thread.
*Engine not included.
This is custom made, weighs around 20oz.
Works on Powerhorse 208cc, Predator Hemi, Honda GX160, GX200, predator 212cc, lifan 7hp...
I think it works in all who are Honda clone. please check the measurements of your engine before you buy.
center hollow to hollow 1"13\16 or 46mm (see photos for details)
*Free shipping!
*INTERNATIONAL CAN TAKE 30 DAYS!
Made in U.S.A.
We only ship to paypal confirmed address.
Florida residents pay 7% taxes.
Finding the Correct Pipe Thread Size
National Pipe Threads (NPT)
Pipe sizes do refer to physical dimensions, but the plumbing industry
standard for the sizes of pipe is not always as straight-forward as
measuring the pipe. Measuring the pipe will oftentimes mislead you into choosing the wrong pipe, so do take care.
The "pipe thread size" as shown in column 3 of the table below is
measured and based on the inside of the pipe. But, to actually determine
the size of a pipe, the outside diameter of each pipe or fitting must
be measured and compared to the table for size identification. For
example, a 3/4" NPT pipe thread has an outside diameter of 1.050 inches.
Each thread size has a defined number of threads per inch (TPI). The
3/4" NPT pipe thread has 14 threads per inch. Both the TPI (threads per
inch) and OD (outside diameter) of the thread are required for positive
identification of thread size because several sizes have the same TPI.
Please check my other Header (on other audition)