Made in the USA To the highest quality, don't be fooled by the competition that makes everything in China! the Chinese have copied my products with the worst quality!
... take a moment and look carefully at the quality (the photos speak
for themselves) see the comments of my 100% satisfied clients... More than 10 years in the
manufacture of these exhausts from Florida USA.
You must know this before you make your purchase!
-There is no painting in this exhaust, Rust can come out over time, "solution" you applies high heat paint.
-This muffler is a little more Loud than the factory.
-This exhaust will change color due to the high heat generated by the engine.
Please! look at
all the pictures to know if it will work on your application, compare
all the measurements using a measuring tape to make sure it does not hit the fender or frame.
This been tested on Predator 212cc (6.5hp) Predator Hemi, Engine From Harbor Freight, Honda GX160, GX200, Tillotson Hemi 212 Engine, XtremepowerUS Electric Start 7 HP, BILT HARD 7HP 212cc Horizontal Shaft Gas Engine, AlphaWorks Gas Engine 7HP 212cc, also tested on Powerhorse 208cc, DuroMax XP7HPE (no tested on other engine)
Exhaust pipe Made in U.S.A.
We only ship to paypal confirmed address.
Florida residents pay 7% taxes.
-------------Finding the Correct Pipe Thread Size
National Pipe Threads (NPT)
Pipe sizes do refer to physical dimensions, but the plumbing industry
standard for the sizes of pipe is not always as straight-forward as
measuring the pipe. Measuring the pipe will oftentimes mislead you into choosing the wrong pipe, so do take care.
The "pipe thread size" as shown in column 3 of the table below is
measured and based on the inside of the pipe. But, to actually determine
the size of a pipe, the outside diameter of each pipe or fitting must
be measured and compared to the table for size identification. For
example, a 3/4" NPT pipe thread has an outside diameter of 1.050 inches.
Each thread size has a defined number of threads per inch (TPI). The
3/4" NPT pipe thread has 14 threads per inch. Both the TPI (threads per
inch) and OD (outside diameter) of the thread are required for positive
identification of thread size because several sizes have the same TPI.
---------------------------------------------------------------------------------------------------------------------------------------------------------------------
Please check my other Header (on other audition)