Crankbrothers MTB
Pedal Bearing kits
2010 onwards
( excluding 5050 - 3 DH Pedals )
Please drop into our shop mcrbikes


Listing is for 4 bearings
(enough to service both pedals)


--- 5050/ DH Doubleshot 1/
Stamp 1,2,3 ---



High Quality "unbranded" 
OEM spec bearings

Direct from factory
Allowing us to pass
cost savings
to end user.



--- Chrome steel bearings ---


                                                                              - Match /exceed man`specs

                                                                              - Harder metal by composition

                                                                              - Sealed both sides

                                                                       

--- Bearing instilation guide ---


--- Do ---


                                                                              - Use bearing press or similar

                                                                              - Only press bearings outside edge

                                                                              - press bearing squarely

                                                                              - Clean the aperture Prior


  --- Do not ---



                                                                              - Press rubber seal or inner ring

                                                                              - Strike bearing seal /inner ring

                                                                              - Use detergent nr bearings

                                                                              - Pressure wash bike



Please drop into our shop mcrbikes


--- Please read prior to instilation ---


Bearings should never be installed by pressing on the inner race

or rubber seal.Press with an appropriate tool

,like our . .


,only making contact with the metal of bearings outer race.

The bearing aperture must be clean with no rough edgers or burrs.


Bearings that feel smooth before fitting, but then feel rough or gritty

after fitting,are almost always due to the cartridge being poorly seated


If the bearing cartridge starts to twist ,under no circumstances

should you continue to install .Stop, gently remove, then re-install.

Even a slight twist can damage the bearings inner races irrevocably.


--- After care ---


For bearing longevity, do not direct a jet of water ,or powerful

grease cutting detergents, toward bearings

( BBs, wheel hub, headsets etc )

water penetration can lead to premature bearing failure.

For service and lubrication




*PLEASE NOTE COLOUR OF RUBBER SEAL VARIES WITH CURRENT STOCK* 

related item links ;


Please drop into our shop  mcrbikes