8 - Genuine Bosch Flow Matched Fuel Injectors Per Order Special Note: Tightly flow matched units ensure smooth engine performance all across the power band. We flow match our units under both dynamic (idle) and static (100% duty) conditions. Most companies do not match units under dynamic conditions (various RPM and millisecond power cycles). Not matching units dynamically can lead to rough idle and poor overall performance.
Manufacturer	Genuine BOSCH (Beware of knocked off units being sold as "Bosch Type/Style")
Flow rate	420cc/min at 3bar (43.5 psi) 485cc/min at 4bar (58.0 psi)
High Impedance Coil	14.0 OHMS
Connector Type	EV1
Overall injector Length Injector Length o-ring to o-ring Injector O-ring Size	77mm or 3.0 inches 65mm or 2.5 inches Will fit standard 14mm fuel rail / intake (upper and lower)
Intended Use:	High flow units, designed for modified engines only NOT to be used as "stock" replacements - will require ECU tuning
Can be used on the following vehicles:	See vehicle chart (view listing in desktop/classic mode) If no chart is listed please feel free to shoot us an email your vehicle information

  

 Mobile device users, switch to "classic/desktop mode" to view AND verify compatibility in vehicle fitment chart.

 

Reconditioned in the USA using genuine brand names ONLY (Bosch, Denso, Delphi, Siemens, etc). We do not sell replicas or low quality imported injectors.

Reconditioning Process:

• Thorough Electrical Inspection to verify resistance is within specs
• Disassemble and externally clean injectors
• Internally clean via numerous ultrasonic baths while activating injectors using special solutions
• Back-flush to remove any internal debris left behind (multi-step process)
• Flow test injectors and gather data. If injectors are not back up to specs, the previous 2 steps are performed until we achieve the results we’re looking for. Depending on their condition some fuel injectors may spend up to 8 hours in ultrasonic baths.
• Once injectors are back up to OE specifications they are then lubricated to extend shelf life
• Injectors are reassembled with new OEM high quality components (seals, 0-rings, caps, filters etc..)
• For quality assurance, injectors are flow tested one last time before being shipped

 

Warranty and Returns - All warranty claims will be handled as exchanges only. Parts will not be eligible for return for a refund if used, you will receive replacements, no exceptions. To be eligible for a return for a full refund, parts must be unused and in original packaging. If parts have been taken out of packaging and require re testing and re packaging,  a re stocking fee of up to 25% may be assessed. Return shipping will be covered by buyer.