ZADI Compartment Lock and latch
common replacement part fitted to many motorhome and caravan doors.
Compact design, the
door handle pops out
Internal cranked locking
catch
Complete with ZADI
barrel and key set
Complete with
neoprene gasket
Simple to fit
Fits doors up to 40mm
thick
If you buy more than 1 latch, they will be keyed alike, so the same key opens them all
This ZADI STANDARD SERIES compartment lock is common to many mobile vehicles built in the U.K. such as the Swift Autotrail and European marks such as Hymer Mobile. These door catches are popular with vehicle converters because of the ease of use, ease of fitting and ease of use for the end customer. That alongside a sleek smooth shape that blends onto the vehicle body.
The Zadi Std Series lock operates on a Robust 90-degree twist action.
To operate put the key into the barrel, turn the key and the external handle pops out towards you making it obvious the door is now unlocked. A 1/4 turn on the handle and the door catch is released. To lock the door latch it is simply a case of twisting the locking catch and pushing the handle back flush into the mounting with a turn of the key it is locked and secure.
The fitting of this lock is simple and takes seconds. Anybody can do this. You open your existing latch which reveals 2 external screws. Remove these. Undo the M12 bolt on the rear of the Lock holding the catch on and remove the entire unit. To refit the new lock pass it through the door hole taking care to keep the supplied neoprene gasket in place. Using suitable screws (not supplied) secure the barrel in place, then fit the rear latch washer and finally the m12 bolt and tighten.
By fitting the cranked latch either rear or front facing and with the help of some m12 spacers / washers (not supplied) you can configure this latch to work with door thicknesses between 22 and 44mm! You could make a strike plate for this lock that is cranked or even slot the outer door frame if it is deeper to accept the latch. You can adapt the lock to work how you would like.
SPECIFICATION
Handle size = 48 x 36mm
Handle seat = 56 x 46
mm
Face to latch = 22 -
40 mm
Latch length = 51mm
Overall depth = 47 mm