Minifigure Display Case Frame
MINIFIGURES NOT INCLUDED
I started BrickFrames
about 5 years ago. I love Lego, so pride myself on providing a perfect frame to
show off your Lego minifigures. I am one of the largest sellers of minifigure
display Frames on Ebay. With 100% positive feedback you can assure yourself the
perfect service. I make every frame to order as I am an individual rather than
a ltd company churning them out. This means I can alter anything to suit your
requirements (just ask).
This listing
gives you choice of frame type, frame colour and brick colour. Please read below about the changes in frames.
If you would
like a different configuration of bricks please leave a note on checkout or
send me a message
MINIFIGURES NOT INCLUDED
The Frame
I have always
used the Ikea Ribba frame. 25cm x 25cm x 4.5cm with a 2.6cm gap between the Perspex
front and the back to house the minifigures. This frame has a crystal clear Perspex
front that protects your figures from dust and dirt unless you want to remove
it to have access to your figures all the time. In Sept 2020 Ikea discontinued
the Ribba Frame. To ensure people with Collectable Minifigure
collections can continue to display their new sets along side their old ones I
have sourced an almost identical Ribba Frame from a new supplier. These frames
continue to come in black, white and oak.
The new frames
from Ikea are the Sannahed. An absolutely stunning 26.7cm x 26.7cm x6cm frame.
The internal gap is a staggering 4.3cm and will house just about every figure
and accessory that has ever been produced. This frame has the ability to be
hung on the wall, displayed on a surface with the angle bracket or due to its
sheer thickness just free standing up right.
Please choose
which frame you want at check out.
Insert and Bricks
These frames
include genuine ?Official? Lego inverted (angled) bricks. The
standard brick is the 2x2 but where figures have accessories etc they are often
swapped for 2x3 inverted slopes or a combination or 2x2, 2x3, 1x2 or 1x3
inverted slope to show off the figures and accessories to their best. The frame
sent will have the same configuration as in the picture but again if you want
specific accessory bricks or arrangements please leave a note when ordering.
Some sellers
stick the bricks to the printed background. They will say they use extra thick
card. Over time this card will warp. At Brickframes I stick all my bricks to a
crystal clear 2mm acrylic insert that sits in front of the background. I use a
very special solvent. It is extremely watery unlike glue. Therefore when the
brick is pushed against the acrylic it disperses under the brick but surface
tension prevents it from coming out from around the sides of the brick. It therefore
leaves a perfect, crisp finish along the edge of the brick.. Be aware anyone
using glue will have excess glue visible around the sides of the bricks. The
solvent I use is so strong that once stuck you will struggle to remove the
brick. The insert is therefore completely resilient to any knocks during its
life and bricks will not fall off when figures are pushed onto their bricks..
The background
are professionally printed at a local printers using the best and latest
printing machines. (no home printers). As the background is housed between the
back of the frame and the acrylic insert at anytime the background for your
frame can be changed for a different design
Some people want
the figures in leaflet order. If this is a requirement then please leave a note
when ordering so I can ensure this happens. (sometimes the brick arrangement
are aesthetically pleasing so not in leaflet order)
If you cannot see
the design you want message me. I can accommodate just about any request.