If it is used on a relatively expensive CPU, please be sure to test it with water before installing it. Although we test all of them under pressure and water, we still cannot guarantee that one will not leak. Due to the need to add water to test, the copper water block will be on the top of the water block. Please understand that there are spots or fingerprints, it will not affect the use!

Introduction of Silver water block:
1. Application: Exclusive water-cooling head, liquid-cooling plate, and water-cooling exchanger for semiconductor refrigeration chips. The front and back are both flat and right angles, which are completely consistent with the cooling chips. They are tailor-made for semiconductor cooling chips. make.
2. Material: aluminum
3. Pagoda faucet: outer diameter 9.5mm (can be connected to a soft water pipe with inner diameter of 7~8mm), length 15mm (manual measurement)
4. Polished very smooth, zero-distance contact with the chip, better heat absorption effect
5. Size: width is 40mm, thickness is 12mm, length is 40mm, 80mm, 120mm, 160mm, 180mm, 200mm, 240mm

 Introduction of blue water block:
1. Main functions: special water-cooling head for cooling sheet, flat water-cooling plate, CPU water-cooling radiator, DY water-cooling module
2. Material: aluminum, blue is anodized
3. Pagoda faucet: outer diameter 9.5mm (can be connected to a soft water pipe with inner diameter of 7~8mm), length 15mm (manual measurement)
4. Polished very smooth, zero-distance contact with the chip, the internal fins are dense, and the heat exchange effect is better
5. Product size: width is 40mm, thickness is 12mm, length is 40mm, 80mm, 120mm, 160mm

Notice:
1. The installation of the water block requires a certain amount of hands-on ability. If you encounter any unclear points during installation, please contact customer service in time.
2. The water cooling kit is delivered after 100% pressure test, but if it is installed inside a computer or other electronic products, first check for liquid leakage to ensure that there is no liquid leakage before powering on. If there is liquid leakage, the circuit board needs to be dried with a hair dryer and then powered on! Remember!

 Note: The water blocks are mass-produced, not handicrafts. Customers who have very strict appearance requirements, please purchase carefully, thank you!

The water block is also called a heat exchanger. It doesn't matter which is the water inlet and which is the water outlet. Each water block has passed the 3KG static water pressure test before leaving the factory without leakage. Please note that the hydraulic pressure should not exceed 3KG. The problem is not responsible!

Copper water cooling block thickness 10mm