4 Axis for medium size Router Mill Plasma or Laser

1.  5 axis breakout board

• 

• Description:

  • It can most connection 5pcs driver and control 5pcs motor in the same time
  • It is with 4-wire limit switch to insure our safty movement
  • It is with relay port to contro the cnc spindle
  • Working voltage is 5VDC and support with MACH3,EMC2,KCAM4 software
  • Size:9x5.7cm

   

   

   

  25-pin parallel port control is defined as follows:  

  DB25 control pin (PIN)	The pin of the drive board	Comment
  1	STEPB	B(Fifth axis)pulse signal
  2	STEPX	X(First axis) pulse signal
  3	DIRX	X(First axis) direction of the signal
  4	STEPY	Y(Secondaxis)pulse signal
  5	DIRY	Y(Second axis)direction of the signal
  6	STEPZ	Z(Third axis) pulse signal
  7	DIRZ	Z(Third axis) direction of the signal
  8	STEPA	A(Fourth axis) pulse signal
  9	DIRA	A(Fourth axis) direction of the signal
  10	LIMIT-1	Limit input interface 1
  11	LIMIT-2	Limit input interface 2
  12	LIMIT-3	Limit input interface 3
  13	LIMIT-4	Limit input interface 4
  14	DIRB	B(Fifth axis) direction of the signal
  15	Vacant
  16	RLY	Relay control
  17	EN	All axis enable
  18-25	GND	GND

  Remark:this 5 axis breakout board can connction with many driver type as a CNC 3/4/5 axis driver controller kit,pls if you intresting pls contact us!

  

• 
  

2.  CW5045 high microstep stepper motor driver

Description:

• Input voltage: 24-50VDC
• Output current: 1.3,1.8,2.3,2.7,3.2,3.7,4.2,4.5A
• Mircostepping: 1(1.8°),1/2,1/4,1/8,1/16,1/32,1/64,1/128,1/256;     
•                      1/5,1/10,1/25,1/50,1/125,1/250

• Protect form: Overheated  protect, lock automatic half current ,error connect protect
• Working environment: Temperature-15-40deg Humidity<90%
• It is fit for NEMA17-23 two and four phase stepper motors whose current is small than 4.5A, 

Switch Choice: (ON=0,OFF=1) 

1.Microstepping choice:

2.Current choice: 

3.Full current or half current choice: SW4:0=Full current; 1=half current

We also can offer customer NEMA17-23 stepper motors,so if you need pls contact us.

Application Notice:

1. To avoid use in the oil contamination,dust and corrosive gas environment
2. To lay it in a place with good ventilation
3. Pls note the connection with right power(+ and -) to avoid broken the driver
4. Pls test it when confirm the connection is right.

2. Stepper Motor

Motor lead wires:

Red:       A+

Green:   A-

Yellow:   B+

Blue:      B-

400W 36V 11A DC Switching power supply