This universal kit converts old bed base control boxes with an easy-to-install 3 step process and includes a new wireless remote to control your head and foot motors: Head Up, Head Down, Foot up, and Foot Down. Used to replace a lost or broken remote when there are no more replacements available or in budget. THERE ARE NO PRESETS ON THIS CONVERSION KIT (like 1 touch flat or memory positions) EVEN THOUGH THE REMOTE YOU RECEIVE WILL HAVE A  FLAT BUTTON, IT ITSNT A 1 TOUCH BUTTON. IF YOU NEED PRESETS OR ONE TOUCH BUTTONS, VIEW OUR OTHER KIT FOR $70 MORE

This kit includes all the wiring and harnesses needed to make your conversion. Total installation should take no more than 5 minutes but it does require tipping the bed on its side. If you want to ensure that this model is compatible, look at your actuator motors under the bed and verify that they are 24V. (We have converted several bases without issue and almost all of the beds we have looked at that have been made after 2000 use the 24V voltage, but ultimately we have not tested every bed on the market so cutting your wires is at your own discretion. You can however splice them back together if the conversion does not work so ultimately there is not a huge risk.)

We send detailed instructions and even have started recording videos of us converting different models on our showroom to make this as easy as possible. You can view our first video here converting an old Termpurpedic Ergo Premier/Grande by going to youtube and searching "universal bed remote" (it should be the first one... but you'll recognize it by "bedremotes.com")

There are three steps to installing this unit. First, tip your bed on its side and unplug it from the wall. Second, cut the cords of the head and foot actuator motor and strip the forward and reverse wires (see our video). Third, slide each wire into its corresponding hole in our harness and click down the lever with your thumb. Then secure the boxes to your frame with our zip cables we provide, plug the new power cord in, and you’re good to go!

Kit Includes:

1) Conversion Control Box with Wire Harnesses and a Power Supply Cable/Transformer Box with built in heat resistance, short circuit protection, and electromatic wave reduction. Simply click your 4 stripped wires into our four port receptacle and plug the new power cord to a surge protector and you will be up and running.

1) Wireless Remote Control - We program this prior to shipping so just plug in the kit after it’s installed and the remote will work. 

We also sell these remotes as separate items but only one will pair at a time. Split King bases require two kits. You can pair one remote to two bases if you want to synchronize your king.

2) Large Zip Tie Cables to secure the new boxes under the bed

Recommended Items to have prior to install:

1) Wire Stripper or Pair of Scissors (we recommend a good but inexpensive pair of strippers as it will make the stripping process a lot easier and quicker. There are good stripping tools online for about $6

1) Surge Protector. This can be a power strip or single box, but its important to make sure the words "Surge Protector" or some variant are on the unit. Usually you can buy both at walmart but the power strip without surge protection is a dollar or two less.