Here we have a strong metal bracket for hanging a wheel cover tyre
SUITABLE FOR ALL VEHICLES INCLUDING
MOTORHOMES CAMPERVANS, VANS , 4x4
This can be bolted on any part of your vehicle:-
Rear door of a vehicle Inside panel of a vehicle
Front Bonnet of a vehicle
Top Roof of a vehicle
Caravans , horse carriers and SUVs/MPVs
Are you fed up with having your tyre at the bottom underside or otherwise inside your vehicle?
This will allow you to hang your wheel cover complete with rim and tyre anywhere on the vehicle
Comes with the 3 bolts for holding the tyre in place
FITS ALMOST ALL TYRES !!
Grab this unusual and rare item not found easily and with a bit of diy make it a great enhancement to your vehicle
Going on a long journey and need an additional spare tyre (holder)? / Space?
Measurements:
Bottom Metal piece for attaching to the vehicle - 5 holes for bolts predrilled 8 inches (20cm ) by 6 inches (15 cm) Top Metal Piece 5.25 inches (13.2cm) x 5.25 inches (13.2cm)
3 holes predrilled with bolts and nuts supplied to hold all any standard tyre
Gap Protrusion bar between the two metal pieces welded together measures 5.25 inches (13.2 cm) PCB MEASUREMENTS The three holes pre drilled where the bolts (supplied) are put in measure as follows:- Bottom two holes have a gap of 7 cm Top to bottom left and right holes measures 11 cm Further holes can be easily drilled to suite any rim size although at least two bolts must hold the tyre
HEALTH AND SAFETY NOTICE
It is the responsibility of the buyer to ensure that the item is suitable for your vehicle
Ensure that the product is fully and properly secured
Ensure that you have flat supporting plates on the other side of your vehicle if your vehicle panel is thin
Ensure that the tyre and item is fully secure before commencing on any journey
BUY FROM A RELIABLE AND WELL ESTABLISHED BUSINESS
IN STOCK NOW FOR IMMEDIATE POSTAGE!