***If you want to buy more than one items i sell on eBay, ask for combined postage***



 With this adapter cable, you can use: 

A Gotek USB Floppy Drive Emulator 
And/Or
A 3.5" PC Floppy Drive

 Connected SIMULTANEOUSLY to the external drive connector
of ANY AMIGA 500/600/1200!
(note: NOT for Escom A1200)
(set Gotek's jumper to 'S1' for stand alone use, or to 'S0', for use along with a pc floppy)


 Gotek/Pc Drive can be also connected alone either directly to amiga,
or chained connected to external drive(s)!
(note: Gotek drive must have the appropriate firmware for amiga, either Cortex , Hxc  or FlashFloppy )

NEW! Use the 2 small switches to Select Drive order! 
This could be VERY useful, if you also have a Drive Boot Selector installed, 
In order to Boot from either a Gotek/HxC Drive or a PC floppy Drive! 



Fully tested using an Amiga 500 with 1.3 Kickstart 
and Amiga 500+/600 with 2.04 Kickstart,
 (Kickstart 2.04 and above offers booting from external drives, 
using boot menu:press both mouse buttons on power)

And here 
is a great presentaiton of the cable, from a very nice person who bought the cable (Thanks Glen!)



Notes: 

- The cable might work with other floppy emulators too (for example HxC floppy Emu) but i can't guarantee it will do so.
- As the needed 23pin D connector is difficult to find and rather expensive,i use a cut 25pin D connector instead. No need to worry about that, as it will plug perfectly like a real 23pin D connector!
- If you are using HD 3.5" disks along with a pc floppy drive connected to amiga, be sure to cover the HD hole of the disk with a little duct tape in order to enable pc drive's  DD/720Kb  operation mode. 
- Although the adapter is tested with many 3.5" pc floppy drives,i can't guarantee that it will work with any 3.5" floppy drive existed.