NEW KILL SWITCH BUTTON STOP FOR YAMAHA

Kill Button Honda YZ to fit:
YZ80 80-01
YZ85 02-15
YZ125 80-04
YZ250 80-04

Fitting Instructions:
Start by removing the front number board.
Carefully snip any cable ties holding the start and stop switch cables to the bars then un-screw the clamps
and let these hang down.
Locate the connector for the switch on the bike, these are often close by to the headstock on the chassis
but sometimes can be under the tank.
Unclip the connector and remove the switch taking a note of the routing for the wiring.
Clean the connector using contact cleaner such as Maxima Electrical Contact cleaner.
Loosely attach the new switch on to the handlebars in the desired position.
Route the wires as per the old switch and clip the connector together.
Check all free pay in the wires by turning the bars to full extension and making sure the wires don’t pull tight,
adjust if necessary.
Re-fit cable ties to the wires if possible positioning the cables to the back of the bars to prevent damage
from roost.
Re-fit your number board.