Rebit Professional Swedish made TCT Pitching chisel for all stone 20mm

This is a one sided carbide bladed special pitching tool or hand set. Stone masons angle it on its edge and strike it along a line to square and trim granite or other hard stone. Regular sharpening of the tungsten is recommended for safe and efficient use.The pitching tool, is used for cutting of edges. Hold the chisel steady in your hand and never brake at the same time as you hit the shank. Avoid trying to break away stone. Straight hits will give the best result.The tools are also hardened to avoid splitting and mushroom-shaping.

150mm long, 12.7mm shaft diamater 20 mm Tungsten tip.

Made by craftman in Sweden and probably the finest stone chisel on the market.

Using the tools.
- Use the correct size.

- Hit with the full width of the tool.

- On uneven surfaces it is advised to hit lightly until the full width of carbide is in contact with the stone.

- On uneven surfaces it is advised to hit lightly until the full width of carbide is in contact with the stone.

- Grinding advice

- Do not grind the carbide too sharp.
- After grinding, give an edge to the corners
- Do not overheat.Do not Quench .
- Hold the chisel steady against the grinding disc