APPLICATION:

 

- For 99-02 Chevrolet Silverado 1500 2500 3500

- For 01-02 Chevrolet Silverado 1500 HD 2500 HD

- For 00-06 Chevrolet Suburban 1500 2500

- For 00-06 Chevrolet Tahoe

*Do not fit Barn Door or Stepside models

 

- OEM Part Number:GM2503187,GM2502187

- Interchage Part Number: 16526134,16526133

 

FEATURE:

 

- Low Beam Bulb Type: 9006 HB4 (Bulb Not Included)

- High Beam Bulb Type: 9005 Hb3 (Bulb Not Included)

- Turn Signal Light Bulb Type: 3157NA (Bulb Not Included)

- Placement on Vehicle: Front, Left, Right

- Made of material that meet or exceed OEM requirement

- Black Housing Clear Lens

- Type: Halogen Headlights

 

PACKAGE INCLUDES:

 

- 1 Pair of Left Driver Side + Right Passenger Side Headlights Headlamps

 

HOW TO INSTALL:

 

1.Undo the screws, clips, or retainer springs that hold the headlight in place.

2.Disconnect the wiring from the assembly.

3.Detach the headlight from the vehicle to replace it with a new one.

4.Fit in the new headlight assembly.

5.Fix the new headlight into place and make sure that the screws, clips, or retainer springs used are sealed.

6.Reconnect the wiring that was unplugged from the assembly.

 

7.Put back the grille and other components that you removed. Seal them back into place.

 

HOW TO ADJUST:

 

Before you begin to adjust the light, make sure check the alignment of your lights first. Park the vehicle about 10 to 25 feet from the wall with the lights aimed at the wall. The centerlines of the headlights should not be any higher than 3.5 feet above the ground.

 

1. Find the adjustment screws. Firstly, locate the adjustment screws on your vehicle.

 

2. Adjust the headlights individually. The headlights should be adjusted one at a time. Put a rag or towel over a chair in front of the light you want to block. Covering the light assembly directly can damage the plastic lens.

 

3. Adjust the vertical field. The screw on the top of the light housing should be turned clockwise to raise the lights and counterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the light beam shines directly on or just below the center of the tape line on the wall.

 

4. Adjust the horizontal field. The screw on the side of the light housing should be turned to get the right/left adjustment correct. Adjust the lens so that the most intense part of the beam is to the right of the vertical line.

 

5. Test your results.