DIY
PCB ( printed circuit board ) 15mm x 25mm 31 kHz FREQUENCY ZAPPER
+ link to download Dr. Hulda Clark ebook
http://nutesla.com/wp-content/uploads/2010/08/Hulda-Clark-A-cure-for-all-disease.pdf
Building A Zapper - page 19
A 31kHz Frequency Zapper
To complete the zapper you need (not included):
- battery case with a switch (example: https://www.ebay.co.uk/itm/224431966989 )
- a pare of wire with crocodiles (example: https://www.ebay.co.uk/itm/274063405965 )
a small (transparent to see the diode) plastic box to place the PCB in, or just transparent heat shrink tube (example: https://www.ebay.co.uk/itm/180988525633?var=480218519272 200mm 13 mm diameter) to cover the PCB
- a pare of short coper pipes ( grips ),
After building the device:
This ZAPPER is very easy to use. According to Dr Hulda Clark using Zapper for 7 minutes in three series with a break of 25 minutes, the device stops and removes already a significant part problems.
Frequencies recommended by Dr Hulda Clark .
Please note that this is not a Blood Electrifier.
PCB Specifications
# frequency
output 31kHz +-1-2%
# square wave with 0 to 50% duty
cycle(+-2%)
# input voltage 9V DC (battery operated only)
#
output voltage 4-5V DC
# Signal load capacity: output current is about 5-30mA;
Disclaimer
We will do our best to answer any questions relating to this device but Please be aware that we are not Doctors, nor can we make any claim to the effectiveness of treatment.
This device should not be used if you are or believe you may be pregnant
If in any doubt, consult your physician prior to using any electronic or Bio Resonance device.
This device is for experimental use only and is not intended as a medical device.