Taramps High Voltage Amplifier HD3000 W -  3,000 Watts RMS - Taramps Authorized Canadian Dealer 

High Definition and Maximum Performance – These high power line of amplifiers from Brazil bring you the best in engineering and power for your extreme car audio installations. Taramp’s has a well-deserved reputation for building high-quality, high-power mobile audio products. The HD Series amps are some of the best-selling models, with variable high and low pass filters (crossovers), extreme durability, while delivering more reliable performance at standard car voltage on the market today.

Technical Information: 

 

HD 3000 – 1 OHM

HD 3000 – 2 OHMS

OPERATION CLASSClass DClass D
NUMBER OF CHANNELS0101
MAXIMUM POWER@12.6 VDC - 1 Ohm: 3000W RMS
@12.6 VDC - 2 Ohms: 2025 Watts RMS
@12.6VDC - 4 Ohms: 1140 Watts RMS		@12.6 VDC 2 Ohms: 3000 Watts RMS
@12.6 VDC 4 Ohms: 2025 Watts RMS
@12.6 VDC 8 Ohms: 1140 Watts RMS
INPUT SENSITIVITY230mV230mV
SIGNAL TO NOISE RATIO89dB89dB
FREQUENCY RESPONSE10Hz ~ 20KHz (-3dB)10Hz ~ 20KHz (-3dB)
CROSSOVER HIGH PASS (HPF)10Hz ~ 80Hz (-12dB/8ª) Variable10Hz ~ 80Hz (-12dB/8ª) Variable
CROSSOVER LOW PASS (LPF)80Hz ~ Full (-12dB/8ª) Variable80Hz ~ Full (-12dB/8ª) Variable
BASS BOOST0 ~ 10.5dB (50Hz)0 ~ 10.5dB (50Hz)
THERMAL MANAGEMENTSmart Cooler (temperature-driven or audio cooler, with 3 speeds)Smart Cooler (temperature-driven or audio cooler, with 3 speeds)
EFFICIENCY79%83%
INPUT IMPEDANCE18K Ohms18K Ohms
OUTPUT IMPEDANCE1 Ohm2 Ohms
PROTECTION SYSTEMOutput Short circuit / High or Low Supply Voltage / Thermal ProtectionOutput Short circuit / High or Low Supply Voltage / Thermal Protection
MIN. SUPPLY VOLTAGE9 VDC9 VDC
MAXIMUM POWER SUPPLY VOLTAGE16 VDC16 VDC
CONSUMPTION AT REST1.8A1.7A
MAXIMUM MUSIC CONSUMPTION@12.6VDC: 150.5A@12.6VDC: 143.5A
MAXIMUM CONSUMPTION IN SINUSOIDAL SIGNAL@12.6VDC (1KHz): 301A@12.6VDC (1KHz): 287A
DIMENSIONS (WXHXD)9" x 2.56" x 7.32" (229 x 65 x 186mm)9" x 2.56" x 7.32" (229 x 65 x 186mm)
WEIGHT2.0Kg2.0Kg
EAN78985568409037898556840880

Precautions: 

  • Do not mount amplifier to speaker box.  Cyclic Vibrational Failure is #1 fail rate of amplifiers and these are lighter than most so their potential is higher if not followed.
  • Do not wire this amplifier lower than 1ohm nominal Impedance. (Equivalent to ~0.7 ohms DCR or Resistive measurement via DMM).
  • Do not clip amplifier above 15.0v for extended periods of time
  • Do not drive amplifier into clipping + protection for extended periods of time (exceeding 20% THD)