One (1) piece 2-flute End Mill  HSS in Metric sizes from 2mm to 20mm

- Used for milling slots, pockets and plunge cuts.

- 2 Flutes allow maximum space for chip ejection.

- Suitable for use in a wide range of ferrous and non-ferrous materials.

FEEDBACK:

"A+ Excellent service, many thanks." - I.A., Bedfordshire

"As described, fast dispatch and delivery 5*" - G.H., Cheshire

"Excellent service as always - Thank you" - D.A.L., Chesire

Shank sizes vary and can be greater or smaller than the flute diameter, it could have also have a weldon shank (with a flat)- contact us for details

For further details about this or any other of my products I can be contacted via eBay message service or the contact details below.

Please note that when a purchase is made by Paypal, delivery will only be made to the Paypal registered address for buyer and seller protection.

Please Note - For courier shipments to Malta, Cyprus, Canary Islands and certain other offshore destinations as well as Northern Ireland and Scottish highlands we reserve the right to make a surcharge for the extra costs incurred. Postal costs to customers in Italy will also be liable to a surcharge for items sent by post to cover the cost of 'International Signed For'.

NB please note that all photos should be for reference only due to the variation within each items (sizes etc.) and manufacturers may change packaging from time to time. We do, however, do our best to ensure that items are as described in the above description.

We also do our best to ensure that items purchased before 4pm on a working day go out on the same day if by Royal Mail. Courier items need to be ordered before 1pm to ensure a same day despatch.