2X 18V 900Rpm HF drill motor

2X UHMW Drill motor mounts

2X 4" rubber tread wheel w/Steel hex insert

1X 20A Dual-Esc 2-4S With Mixing

1X  Led power indicator light

1X  Power link - FingerTech switch  w/ 3/32" hex driver

Misc parts: 10-32 tap, 16X 10-32 x 0.3125 set-screws, 2X M5 Left-hand screw (for securing the wheel), 8X #6 x 1" Deck screws, 10X blue ring terminals,  barrier strip- 8 position.

This kit gets you all the drive-train parts needed to get you moving.   You will need to provide your own Radio transmitter and receiver,  Charger and Battery (with xt60 connector) ,  A frame of your choosing,  and about 2-hours of labor to modify the drills.  tools required:  terminal crimper,  tap wrench or another drill, 3/32 drill bit, #2 phillips screw driver.

Here is a link to a series of videos i made, detailing how to use these drills to build a robot.  All the steps are there, but its not easy to digest.  I will in future make an updated video for this specific kit.   https://www.youtube.com/playlist?list=PL0trvo4-J7IBcAjrtY1MfWdLwj9OUsCaE