Plastic 1/32 scale 2021 Indy Car Body. 3D printed from PLA plastic. The body Fits Scalextric Start F1 racing car C4114 and C4113 chassis (Orange or Black F1 Cars). You will need to trim radiator intake down .2 inches on the chassis, line up the chassis and install screws.
Body is made of PLA plastic and can be painted with acrylic, enamel, and plastic automotive paints. For best result, spray with Rust-Oleum primer - 2 in 1 filler & sandable and then sand with 400 or smooth grit paper.
Design
Wheel Base - 3.85 inches
Body Width - 2.5 inches
Total Length - 6.25 inches
Part included:
- 1 Body
- 1 Road Rear Wing
- 1 Road Front Wing
- 1 Oval Rear Wind
- 1 Oval Front Wing
- 4 wheel spacers (.1 in)
- Canopy
- Canopy Trimming Tool
Reminder: Scalextric Start F1 Racing Car NOT INCLUDED.
32 Scale Indy Slot Car Assembly Tips
- Remove body from Scalextric Start F1 car
- Save 4 Screws
- Remove rear Wing from chassis
- Trim radiator intake on chassis by .25 inches
located in front of middle mounting posts
- Remove wheel from chassis and install spacer at
each wheel
- Install body on chassis using the 4 screws and
verify fit
- Finishing model tips
- Use Super glue for wings and driver helmet
- Use X-Acto knife to remove any flashing and printer
supports
- Use multiple coats of Rust-oleum Filler-Primer and
sand lightly with 600 grit paper 90 degrees from the layer lines. (fills the gaps between layer lines)
- Reinstall finished body on chassis using 4
screws
- Use Canopy trimming tool cut out canopy
- Use Zap clear canopy glue to mount canopy after painting model