Product Feature:
1. Made of high-quality materials, durable and practical
2. This product is connected to a DC 3-5 V power supply at the input end. When the secondary high-voltage output is not connected to a high-voltage rectifier diode or capacitor, the output two stage line terminals can generate a purple high-temperature arc with a length of ≤ 0.8 cm or so
3. The transformer is resin encapsulated, with high safety and stable performance
4. When connected, the temperature is very high, making it easy to instantly light paper and cigarettes, and even fine iron wires can burn sparks everywhere
5. Wide application range, DIY parts are suitable for electronic enthusiasts to enjoy the fun of hands-on operation
Product parameters:
Voltage: DC3-5 V
Current: 5A
Power: Above 15W (recommended to use 3.7V 18650 lithium battery)
Working frequency: 20KHZ-25KHZ
Arc distance: 5-8MM
Precautions:
1. Check if the input positive and negative are connected correctly before powering on. Before powering on, the appropriate distance between the high-voltage line terminals must be adjusted within 0.2-0.8 centimeters. The arc pulling distance of the high-voltage line is proportional to the battery voltage and capacity used. The higher the input voltage, the longer the arc
2. High voltage modules should be avoided from being energized during high voltage no-load use. When testing the arc distance, the experiment should be conducted from short to long. It is strictly prohibited to exceed the 1cm limit for arc pulling distance when energized. Due to the inability to release high voltage energy, the module is easily damaged.
3. The module has high power and is not suitable for internal heat dissipation, so it cannot be operated for a long time. It is recommended to control the working time within 1 minute and pay attention to heat dissipation
Regarding power supply:
Input DC 3-5 V, current above 3A, power above 15W, to ensure sufficient power supply voltage and current. When the voltage is below 3V and the current is below 5A, it will not work. Mobile phone chargers and power banks cannot be used for power supply because the output current is too small to move and can easily burn. It is recommended to use a 3.7V 18650 lithium battery for power supply, which has good effect. If the distance is too long and cannot generate an arc, it will easily damage the transformer, Please shorten the discharge distance to a suitable position, or increase the voltage. The higher the input voltage, the longer the discharge distance. The limit is around 0.8 centimeters when the input limit voltage is 5V.
Regarding the discharge needle:
Due to the generation of high-temperature ion electricity, the discharge needle is made of high-temperature resistant iron metal, with a pointed needle structure at both ends. The discharge is carried out in a relative position, and the sharper the head, the easier it is to concentrate energy for discharge. After using it for a period of time, the discharge needle will oxidize and passivate, resulting in a decrease in discharge performance and a shorter discharge distance. Please clean the discharge needle again and restore it.
Packaging list:
DIY kit * 1
