4 Axis USB Mach3 Motion CNC Controller Card

1. USB interface is applicable to any netbook, notebook, desktop, tablet and other PC compatible computers with USB interface;
2. As long as Mach3 can run, the control card can be used;
3. Number of control axis: X.Y.Z.A axis;
4. Maximum step-pulse frequency is 100KHz,which is suitable for the servo or stepping motor.
5. Support computer system:Windows 2000/XP/Windows 7/8/10.

4 general-purpose isolated relay drive output interface, can drive four relays for controlling the spindle starts, forward rotating and reverse rotating, pumps and other device. 4 general-purpose inputs, you can connect the limit switch, estop switch, probe , back to zero and other device. Have 0-10V signal output,you can use mach3 software to control the spindle motor speed.	Support for 4 Axis linkage, you can connect four stepper motor drives or servo drives; Maximum step-pulse frequency is 100KHz,which is suitable for the servo or stepping motor; Need use external 24V DC power supply to isolate USB and external port, and to make the system more stable. MCU model: three generation 32-bit STM processor Communication plug-in: RnR motion control card - ECO-2.0 One status LED, indicate connection status on the board.	Support for connecting electronic handwheel; Note: The electronic handwheel selection 5V voltage output models,more than 5V output will damage the hand wheel interface.

 Please strictly follow the instructions and warnings before using this product:

• It is recommended that the limit switch and emergency stop switch must be installed first and can be used normally.
• The output singal of theelectronic handwheel must be 5V, more than 5V output will damage the hand wheel interface.
• This interface can output 0-10V analog signals.
• USB interface is applicable to any netbook, notebook, desktop, tablet and other PC compatible computers with USB interface.
• This control board does not require any drivers to be installed,as long as Mach3 can run, the control card can be used;
• Whether frequency converter is supported: Yes
• Support PWM: Yes

• Widely use in CNC Router,Milling Machine,Engraving Machine,Carving Machines,Cutting industry,Medical equipment,industrial equipment and automation devices etc.

 Size: 8.0x8.5cm/3.15x3.35inch

    Quantity: 1 Set

    Note:
    1.Please allow 1-2cm error due to manual measurement. pls make sure you do not mind before you bid.
    2.Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!