Specification :

 

Condition: 100% Brand New and High Quality

Made of materials that meet or exceed OEM requirements

Color: Black Housing + Clear Lens

Low Beam Bulb Type: 9002 H4(bulb not included)

High Beam Bulb Type: 9002 H4 (bulb not included)

Turn Signal Bulb Type: 3157A (bulb is included)

Fits for :

 

For 2014-2017 Toyota Tundra  SR5 / SR / TRD Pro / Limited

For 2018-2021 Toyota Tundra  SR5 / SR

 

PARTSLINK: TO2503219, TO2502220,TO2502235

PART NUMBER: 6221-0157L, 6221-0157R, 6221-0158L

HOLLANDER: 114-60251BL, 114-60250BR, 114-60371L

Packing List :

 

1 Pair of Headlights (Driver & Passenger Side)

 

 

HOW TO INSTALL:

 

1.Undo the screws, clips, or retainer springs that hold the headlight in place.

2.Disconnect the wiring from the assembly.

3.Detach the headlight from the vehicle to replace it with a new one.

4.Fit in the new headlight assembly.

5.Fix the new headlight into place and make sure that the screws, clips, or retainer springs used are sealed.

6.Reconnect the wiring that was unplugged from the assembly.

7.Put back the grille and other components that you removed. Seal them back into place.

 

HOW TO ADJUST:

 

Before you begin to adjust the light, make sure check the alignment of your lights first. Park the vehicle about 10 to 25 feet from the wall with the lights aimed at the wall. The centerlines of the headlights should not be any higher than 3.5 feet above the ground.

 

1. Find the adjustment screws. Firstly, locate the adjustment screws on your vehicle.

 

2. Adjust the headlights individually. The headlights should be adjusted one at a time. Put a rag or towel over a chair in front of the light you want to block. Covering the light assembly directly can damage the plastic lens.

 

3. Adjust the vertical field. The screw on the top of the light housing should be turned clockwise to raise the lights and counterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the light beam shines directly on or just below the center of the tape line on the wall.

 

4. Adjust the horizontal field. The screw on the side of the light housing should be turned to get the right/left adjustment correct. Adjust the lens so that the most intense part of the beam is to the right of the vertical line.

 

5. Test your results.