Metal punch stamp: Good for stamping aluminum, brass, copper, silver, gold etc.. (also fits for annealed steel and hot stamping on steel)
DETAILS:
-Stamp size (widest side of rose) = 25mm (0.98")
- Stamps' steel rod is 90-100mm.
- Stamps' steel is hardened (Carbon steel U8A)
- Stamps are made by deep laser engraving 1mm-1.5mm
- Recommended thickness of blanks from 1.5-2mm, using thinner blanks might not give good result, especially using bigger size stamps
RECOMMENDATIONS FOR USING THE STAMP:
- For punching use hammer and place the blank on a hard, smooth surface (the best metal, steel plate or anvil), don't be afraid to hit hard NOTE: Brass 'hammers' do not fit for these stamps
- If the stamp gets rusty, brush it with simple hard sponge and boil it for 10 minutes in water with soda.
- For bigger stamps from 20 mm it can be hard to get the best result using hammer, so my advice is to use press.
- If the stamp is not being used for a long time, it is recommended to keep it lubricated with oil.
Purchased in December for a project, but it didn't work out for us.