SpeakerCraft In Ceiling/In Wall Speaker Dog Ears (Each  - Made in USA)

These were made for the AIM7 Two Speakers.  Might fit others.  Please confirm sizes from pictures. (in mm)

Shipping is combined so the more you buy the more you save!

It is important to use the screws that came with the speakers or a similar size.  If the screws are larger use a drill bit to drill out the screw hole on the new dog ear.  If they are too tight it could break the new dog ear.

This is a brand new 3d printed Speaker Dog Ear.  Fits SpeakerCraft speakers (May fit others or I can make some if you need).  Shipping is combined so the more you buy the more you save.

Contact if you would larger orders

• Sizes in picture are in MM(must use same screw as came from factory to work).
• Comes as Each
• Printed using PLA Filament in high resolution
• If there is not enough please contact us for lead times.
• No screws included.
• Printed by us and not outsourced (Made In USA)