|
|
|
|
|
|
|
|
Specifications:
1) Thickness: 1" / 25mm
2) Vehicle Bolt Pattern(PCD): 5x4.5" / 5x114.3mm
3) Wheel Bolt Pattern(PCD): 5x4.5" / 5x114.3mm
4) Hub Diameter: 67.1mm / 2.64"
5) Thread Size: 12x1.5 / M12x1.5 / 12mmX1.5
Note:Please make sure you take the proper neasurements gefore purchasing
Package include: 2Pcs Wheel Spacers Adapters
What should I pay attention to during installation?
1) Check to make sure that the wheel spacer fits perfectly with the hub/axle stub and the inner mounting surface of the wheel.
2) Make sure that the wheel bolts being used are of the appropriate length, not too long or too short.
3) DO NOT proceed if both of the wheel spacer do not fit.
4) Please be sure to clean the rust on the hub before starting the installation, otherwise it will affect the working life of the spacers.
5) Make sure that you get 5-7 FULL TURNS of the lugs when installing. Torque them down to the manufacturers specs (up to and not greater than 110ft lbs).
6) Avoid using an impact wrench because improper usage may cause the lug nuts/bolts to break or loosen while driving causing a potential injury or accident.
7) All lug nuts, bolts and torque must be checked after driving the first 50 miles after installation. Afterwards, please check all lug nuts and bolts every 3,000-5,000 miles.
8) Alignment is necessary after installation, this will prevent any wobble and vibration from occurring.
How to measure the fender gap to choose suitable thickness?
1) Line up a straight edge ruler against the sidewall of the tire, use the measuring device to measure from the inside of the ruler to the inner fender lip.
2) Please take multiple measurements and use the smallest data point.(The most closest spot may be at the front or rear edge of the fender). The maximum recommended spacer
thickness= the smallest gap - 3/8"(10mm)
About the wheel bolts:
Your Factory wheel studs may extend past the surface of the wheel spacers. In this case you will need to:
1) Shorten the factory studs.
2) The wheels need to have the open slots (cavities) between mounting holes.
3) Purchase a set of shorter studs and replace them with the factory studs.
Vehicle Fitment Information:
Dodge:
1991-1996 Dodge Stealth
Ford:
2006-2012 Ford Fusion
Hyundai:
2007-2017 Hyundai Azera
2011-2018 Hyundai Elantra
2013-2018 Hyundai Elantra GT
2011-2016 Hyundai Equus
2009-2016 Hyundai Genesis
2010-2014 Hyundai Genesis Coupe
2003-2008 Hyundai Tiburon
2005-2017 Hyundai Tucson
2012-2017 Hyundai Veloster
Jeep:
2007-2016 Jeep Compass
2007-2016 Jeep Patriot
Kia:
2006-2016 Kia Optima
2010-2017 Kia Soul
Mazda:
2004-2018 Mazda 3
2014-2018 Mazda 3 Sport
2006-2015 Mazda 5
2003-2019 Mazda 6
1993-1997 Mazda 626
2016-2019 Mazda CX-3
2013-2018 Mazda CX-5
2007-2012 Mazda CX-7
2007-2018 Mazda CX-9
1995-2002 Mazda Millenia
2006-2016 Mazda MX-5 Miata
1993-1997 Mazda MX-6
1999-2003 Mazda Protege
2002-2003 Mazda Protege5
1993-1995 Mazda RX-7
2004-2011 Mazda RX-8
Mitsubishi:
1991-1999 Mitsubishi 3000GT
1990-2012 Mitsubishi Eclipse
2018-2019 Mitsubishi Eclipse Cross
1999-2012 Mitsubishi Galant
2002-2017 Mitsubishi Lancer
2016-2019 Mitsubishi Outlander
2016-2018 Mitsubishi Outlander Sport
Before&After
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
1.We only accept PayPal.
2.Please do not use the PayPal note field to indicate us to ship to other address. The note there will NOT be read. If you want to change the shipping address, please contact us by eBay messages.
3.(if you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement.)
4.Payment must be received within 10 days as auction ended or order might be delayed.
1. Orders processed within 24 hours of payment verification.
2. We only ship to confirmed PAYPAL addresses. Your PAYPAL address must match your Shipping address.
3. The images shown are not the actual item and are for your reference only.
4. Fast shipping:All our packages use USPS First Class/UPS/Fedex.... Package Service
5. If you have not received your shipment within 15 days from payment , please contact us. We will track the shipment and get back to you as soon as possible with a reply. Our goal is customer satisfaction!
1. You have 30 days to contact us and 10 days to return it from the date it was received. If this item is in your possession more than 7 days, it is considered used and we will not issue you a refund or replacement. There are NO EXCEPTIONS!
2. All returned items must be in the original packaging and you must provide us with the shipping tracking number, specific reason for the return, and item custom lable.
3. We will refund your full winning bid amount, upon receipt of the item in its original condition and packaging with all components and accessories included, AFTER both Buyer and Seller cancel the transaction from eBay. OR, you may choose to have a replacement.
4. Return shipping is to be paid by the Buyer.
We maintain high standards of excellence (five stars review)and strive for 100% customer satisfaction! FEEDBACK IS VERY IMPORTANT TO US. We request that you contact us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns.
 New List Item
Hot Item
Shop Category
|
2x 1 Inch 5x4.5 Wheel Spacers Hubcentric For Hyundai Elantra Ford Fusion Mazda 3
Specifications:
1) Thickness: 1" / 25mm 2) Vehicle Bolt Pattern(PCD): 5x4.5" / 5x114.3mm 3) Wheel Bolt Pattern(PCD): 5x4.5" / 5x114.3mm 4) Hub Diameter: 67.1mm / 2.64" 5) Thread Size: 12x1.5 / M12x1.5 / 12mmX1.5 Note:Please make sure you take the proper neasurements gefore purchasing
Package include: 2Pcs Wheel Spacers Adapters
What should I pay attention to during installation?
1) Check to make sure that the wheel spacer fits perfectly with the hub/axle stub and the inner mounting surface of the wheel. 2) Make sure that the wheel bolts being used are of the appropriate length, not too long or too short. 3) DO NOT proceed if both of the wheel spacer do not fit. 4) Please be sure to clean the rust on the hub before starting the installation, otherwise it will affect the working life of the spacers. 5) Make sure that you get 5-7 FULL TURNS of the lugs when installing. Torque them down to the manufacturers specs (up to and not greater than 110ft lbs). 6) Avoid using an impact wrench because improper usage may cause the lug nuts/bolts to break or loosen while driving causing a potential injury or accident. 8) Alignment is necessary after installation, this will prevent any wobble and vibration from occurring.
How to measure the fender gap to choose suitable thickness?
1) Line up a straight edge ruler against the sidewall of the tire, use the measuring device to measure from the inside of the ruler to the inner fender lip.
About the wheel bolts:
Your Factory wheel studs may extend past the surface of the wheel spacers. In this case you will need to:
Vehicle Fitment Information:
Dodge: 1991-1996 Dodge Stealth
Ford:
Hyundai:
Jeep:
Kia:
Mazda:
Mitsubishi:
Before&After
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. 1.We only accept PayPal. 2.Please do not use the PayPal note field to indicate us to ship to other address. The note there will NOT be read. If you want to change the shipping address, please contact us by eBay messages. 3.(if you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement.) 4.Payment must be received within 10 days as auction ended or order might be delayed.
1.We only accept PayPal.
2.Please do not use the PayPal note field to indicate us to ship to other address. The note there will NOT be read. If you want to change the shipping address, please contact us by eBay messages.
3.(if you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement.)
4.Payment must be received within 10 days as auction ended or order might be delayed.1.We only accept PayPal.
2.Please do not use the PayPal note field to indicate us to ship to other address. The note there will NOT be read. If you want to change the shipping address, please contact us by eBay messages.
3.(if you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement.)
4.Payment must be received within 10 days as auction ended or order might be delayed.
1. Orders processed within 24 hours of payment verification. 2. We only ship to confirmed PAYPAL addresses. Your PAYPAL address must match your Shipping address. 3. The images shown are not the actual item and are for your reference only. 4. Fast shipping:All our packages use USPS First Class/UPS/Fedex.... Package Service 5. If you have not received your shipment within 15 days from payment , please contact us. We will track the shipment and get back to you as soon as possible with a reply. Our goal is customer satisfaction!
1. You have 30 days to contact us and 10 days to return it from the date it was received. If this item is in your possession more than 7 days, it is considered used and we will not issue you a refund or replacement. There are NO EXCEPTIONS! 2. All returned items must be in the original packaging and you must provide us with the shipping tracking number, specific reason for the return, and item custom lable. 3. We will refund your full winning bid amount, upon receipt of the item in its original condition and packaging with all components and accessories included, AFTER both Buyer and Seller cancel the transaction from eBay. OR, you may choose to have a replacement. 4. Return shipping is to be paid by the Buyer.
We maintain high standards of excellence (five stars review)and strive for 100% customer satisfaction! FEEDBACK IS VERY IMPORTANT TO US. We request that you contact us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns.
Copyright of Top-liftsupport. All rights reserved. |
