CUSTOM METAL STAMP || Custom Metal Die || Metal Stamps || Jewelry Punch Stamp | Steel Stamp | Custom Tiny Metal Stamp

Metal punch stamp: Good for stamping aluminium, brass, copper, silver, gold and ect. (also fits for annealed steel and hot stamping on steel)

If you have questions feel free to write me. If You are not sure, if Your logo fits to a stamp size You need, please contact before buying.

ORDER DETAILS:

- a customer should send high-resolution black and white (not grayscale and not colourful) logo in JPEG, PNG, AI, EPS, CDR or PDF format via Etsy messages after purchasing (or before purchasing, to make sure the stamp can be made)

-A logo can be small, from 2 mm (if You choose the smallest size, the best is only initials or very simple logo, to be easier to understand- usually 1 letter needs to be 1mm, dots are included also as a letter) but the lines of that logo must not be less than 0.2 mm in thickness (that allows the stamp to last longer), the least diameter of a steel rod is 8 mm

- Black areas of your logo will be raised on a stamp (black areas of Your logo will be pressed into the blank)

- Please do not send mirrored image

- A length of stamps' steel rod: from 75mm to 100mm (it depends on a size of a logo).

- The stamps' steel is hardened (Carbon steel U8A)

- Stamps are made by deep laser engraving 1mm-1.5mm

-Recommended thickness of blanks from 1.5-2mm, using thinner blanks might not give good result, especially using bigger size stamps

-If the stamp's size is small, You have to note, that it might not be clear because of it's size. For better imagine how Your stamp will look on certain size, shrink Your image till the size You want, print on a paper and see what You have (with the image's lines no thinner than 0.2mm)

RECOMMENDATIONS FOR USING THE STAMP:

-For punching use hammer and place the blank on a hard, smooth surface (the best metal, steel plate or anvil), don't be afraid to hit hard 
NOTE: Brass 'hammers' do not fit for these stamps

-If the stamp gets rusty, brush it with simple hard sponge and boil it for 10 minutes in water with soda.

-For bigger stamps from 20 mm it can be hard to get the best result using hammer, so my advice is to use press.

-If the stamp is not being used for a long time, it is recommended to keep it lubricated with oil.

NOTE TO BUYER:

All necessary information, needed to make a stamp, must be written in personalization. The image should be sent after the purchase or before it, to make sure it is doable. If there is only text in personalization and the buyer do not contact via Etsy messages or email, it will be considered as the desired image on the item. If You want only text, but to be in specific font, please also note that in personalization.