Item |
Specifications |
Part Number |
MADLN15SE |
Details |
A6SE series |
Family Name |
MINAS A6 |
Series |
A6SE series |
Type |
Position control type |
Frame |
A-Frame |
Frequency response |
3.2 kHz |
Control method |
Position control |
About control method |
A6SE series driver
(Position control only) does not correspond to the absolute system of using
the serial communication with the host device. It supports incremental system
only. |
Safety Function |
without |
Supply voltage |
Single/3-phase 200 V |
I/F Classification of
type |
Pulse train only |
Dimensions (W) (Unit: mm) |
40 |
Dimensions (H) (Unit: mm) |
150 |
Dimensions (D) (Unit: mm) |
130 |
Mass (kg) |
0.8 |
Environment |
For more details, please
refer to the instruction manual. |
Basic
Specifications
Item |
Specifications |
Input power: Main circuit |
Single/3-phase 200 to
240V +10% -15% 50/60 Hz |
Input power: Control
circuit |
Single phase 200 to 240V
+10% -15% 50/60 Hz |
Encoder feedback |
23-bit (8388608
resolution) absolute encoder, 7-wire serial |
About Encoder feedback |
* Since it can be used
only as an incremental system, do not connect the battery for absolute
encoder. Parameter Pr. 0.15 must be set to "1" (factory settings). |
Parallel I/O connector: |
General purpose 10 inputs |
Parallel I/O connector: |
General purpose 6 output |
Parallel I/O connector: |
2 outputs (Analog
monitor: 2 output) |
Parallel I/O connector: |
2 inputs (Photo-coupler
input, Line receiver input) |
Parallel I/O connector: |
4 outputs (Line driver: 3
output, open collector: 1 output) |
Communication function |
USB |
Communication function:
USB |
USB interface to connect
to computers for parameter setting or status monitoring. |
Regeneration |
No built-in regenerative
resistor (external resistor only) |
Control mode |
Switching among the
following 3 mode is enabled, |