I have for sale a total of two (2) sets of Commodore 64 wall mounting brackets, ordering a quantity of 1 gets you one set, if you want two sets, you will need to order both available. Each set includes a left and right bracket. These are based on (w w w .) thingiverse (. c o m)/thing:3830214/files. Screws are recessed into the brackets to keep from scratching your case, and tilt the system back for increased stability.

I had them printed to display two Vic-20 systems, however they use the thicker breadbin cases, so they did not fit.

These are 100% infill PLA printing for strength to help keep your prized systems up and on display.

These are pre-printed, unsanded, and only available in white. I went this route to paint them to help them better blend in and not stand out against the system.

Again, these are designed for the THIN COMMODORE BREADBIN UNITS. The thicker systems are 4mm taller/thicker than the thin models. The last photo shows the difference between the two (Thanks to iCore64 for the photo), with the thin case on the left and the thicker case on the right.

Units are shipped USPS Flat Rate Small Box, tracking number provided.